Temperature Display; Setting The Temperature In The Refrigerator/Freezer Sections; Possible Temperature Settings - Miele KFN 4898 Series Operating Instructions Manual

Temperature display

In normal operation, the temperature
display shows the current average
refrigerator section temperature and
the maximum freezer section
temperature.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this
temperature to then be shown as a
constant temperature on the display.
Setting the temperature in the
refrigerator/freezer sections
 Touch the temperature display for the
section you want to change.
 Swipe left or right until the
temperature you want is shown in the
middle.
 Tap on the temperature you want to
confirm.
The temperature display will then
change back to the current refrigeration
and freezer temperature in the
refrigeration appliance.

Possible temperature settings

- Fridge zone: 3 to 9 °C
- Freezer zone: -15 to -26 °C
- Additional fridge zone
(Freeze&Cool zone): -2 to 14 °C
Adjusting the temperature level in the
PerfectFresh Active zone
The temperature in the
PerfectFresh Active zone is
automatically controlled between 0 and
3 °C.
The correct temperature
However, if you would like it to be
warmer or colder, e.g. when storing fish,
you can adjust the temperature slightly
in increments.
 Tap .
 Swipe left or right until  is shown in
the middle.
 Tap .
 Swipe left or right until the setting you
want (1: lowest temperature; 9:
highest temperature) is shown in the
middle.
 Tap on the setting you want to
confirm.
The factory default setting for the
temperature level is
Under certain circumstances, a
setting from to
1
temperature to fall below 0 °C. This
can cause food to freeze.
Check the temperature setting.
If you change the temperature setting:
 check the temperature display after a
few hours. It will take this long for the
appliance to give an accurate reading.
- Wait for approx. 6 hours if the
refrigeration appliance is not very full
- Wait for approx. 24 hours if the
refrigeration appliance is full
If, after this time, the temperature is still
too high or too low:
 Adjust the temperature again.
.
5
can cause the
4
41