Understanding The Status Leds - ADTRAN SDG-8610 Quick Start Manual

Service delivery gateway wifi 6 gigabit router
Table of Contents

Advertisement

Adtran
CAUTION!
This product is intended for use with a Class 1 Laser module that complies with FDA 21 CFR 1040.10,
1040.11 and IEC 60825-1. For continued compliance with the above standards, only approved Class 1
laser modules from an ADTRAN approved vendor list should be installed in this product. ADTRAN
cannot certify system integrity with other laser modules. Refer to the ADTRAN Pluggable Optics
Compatibility Matrix (online tool, go to www.adtran.com/pluggableoptics).
Resetting the SDG
A reset button is available if the SDG-8610 needs to be rebooted or restored to factory defaults. To reboot the SDG-8610,
press the Reset button on the back panel of the device for less than 5 seconds. To reset the device to factory defaults,
press the Reset button for 5 seconds or more.

Understanding the Status LEDs

A multifunction status LED on the front of the unit and status LED's on the back panel allow you monitor the device status.
Multifunction Status LED
The multifunction status LED on the front of the unit indicates the device status.
LED state when running SmartOS.
Table 2:  Multifunction Status LED for SmartOS
Color
LED State
Blue
Solid
Red
Pulsing
Green
Pulsing
Light Blue
Pulsing
White
Solid
Amber
Pulsing
Purple
Pulsing
White
Solid
Red
Pulsing
Amber
Pulsing
White
Pulsing
Quick Setup for the SDG-8610 SDG
The SDG product line uses SmartOS. Scan the QR code labeled Intellifi QuickStart located on the back of the unit. You will
be presented with a series of self-guided steps to choose your account password, select gateway or access point
mode, and configure the WiFi SSID and passphrase. The specified account password will be used when logging into the
GUI in the SDG.
6SDG8610-13A
Event
Cold boot
Reboot and System Upgrade (persists over uboot)
Linux booting up
Quick start
Controller WAN up, Internet
Controller WAN down, no Internet
Satellite Set Up
Satellite up
Satellite up, fair signal
Satellite up, poor signal
Reverting
Resetting the SDG
Table 2
defines the multifunction status
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

17600078f1s17600078f2s17600078f3s17600078f4s

Table of Contents