Table of Contents
Advertisement
Note
You can configure SNMP v2 and SNMP v3 parameters via web browser in Configuration →
System → Advanced Settings → SNMP.
12.5 Configure Email
The system can be configured to send an e-mail notification to all designated users when a
specified event occurs such as when an alarm or motion event is detected, or the administrator
password is changed, etc.
Before You Start
The device must be connected to a local area network (LAN) that contains an SMTP mail server.
The network must also be connected to either an intranet or the Internet depending on the
location of the email accounts to which you want to send notifications.
Steps
1. Go to System → Network → Advanced → Email.
2. Configure the email settings.
Server Authentication
Check to enable the function if the SMTP server requires user authentication and enter the
user name and password accordingly.
SMTP Server
The IP address of SMTP Server or host name (e.g., smtp.263xmail.com).
SMTP Port
The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL/TLS
Check to enable SSL/TLS if required by the SMTP server.
Sender
The sender's name.
Sender's Address
The sender's address.
Select Receivers
Select the receiver. Up to 3 receivers can be configured.
Receiver
The receiver's name.
Receiver's Address
Network Video Recorder User Manual
160
Advertisement
Table of Contents
