Table of Contents
Advertisement
Guidance and Manufacturer's Declaration - Electromagnetic Emissions
The Pacifier Activated Lullaby (P.A.L) Model PAL-HOS is intended for use in the electromagnetic environment specified below. The
user should assure that it is used in such an environment.
Emission Tests
RF emissions CISPR 11
R.F. emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations / flicker emissions
IEC 61000-3-3
Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The Pacifier Activated Lullaby (P.A.L) Model PAL-HOS is intended for use in the electromagnetic environment specified below. The
user should assure that it is used in such an environment.
Immunity Test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast transient /
burst IEC 61000-4-4
Surge IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power supply
input lines IEC
61000-4-11
Power frequency (50/60
Hz) magnetic field IEC
61000-4-8
NOTE: U
is the A/C mains voltage prior to application of the test level.
T
Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The Pacifier Activated Lullaby (P.A.L.) Model PAL-HOS is intended for use in the electromagnetic environment specified below. The
user should assure that it is used in such an environment.
Immunity Test
Conducted RF
IEC 61000-4-6
Radiated RF IEC
61000-4-3
© 2023 by NeoLight LLC.
All rights reserved.
Compliance
The Pacifier Activated Lullaby (P.A.L) Model #PAL-HOS uses RF energy
only for its internal function. Therefore, its RF emissions are very low
Group 1
and are not likely to cause any interference in nearby electronic
equipment.
Class B
The Pacifier Activated Lullaby (P.A.L) Model #PAL-HOS is suitable for
Compliant
use in all establishments, including domestic establishments and those
directly connected to the public low-voltage power supply network that
Compliant
supplies buildings used for domestic purposes
IEC 60601 Test Level
6 kV contact
8 kV air
2 kV for power supply lines
1 kV for input/output lines
1 kV line(s) to line(s)
2 kV line(s) to earth
< 5 % U
(>95 % dip in U
) for
T
T
0,5 cycle
40 % U
(60 % dip in U
) for 5
T
T
cycles
70 % U
(30 % dip in U
) for
T
T
25 cycles
< 5% U
(95 % dip in U
) for
T
T
5 s
3 A/m
IEC 60601 Test Level
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2.5 GHz
Electromagnetic Environment – Guidance
Compliance Level
6 kV contact
8 kV air
2 kV for power supply lines
1 kV for input/output lines
1 kV line(s) to line(s)
2 kV line(s) to earth
< 5 % U
(>95 % dip in U
) for
T
T
0,5 cycle
40 % U
(60 % dip in U
) for 5
T
T
cycles
70 % U
(30 % dip in U
) for 25
T
T
cycles
< 5% U
(95 % dip in U
) for 5
T
T
s
3 A/m
Compliance Level
3 Vrms
3 V/m
Electromagnetic Environment –
Guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30 %.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment.
The Mains power quality should be
that of a typical commercial or
hospital environment. If the user of
the [ME Equipments or ME systems]
requires continued operations
during power mains interruptions, it
is recommended that the [ME
Equipments or ME systems] be
powered from an uninterruptible
power supply or a battery
Power frequency magnetic fields
should be at levels characteristic of
a typical location in a typical
commercial or hospital
environment.
Electromagnetic Environment –
Guidance
Portable and mobile RF
communications equipment should
be used no closer to any part of the
Pacifier Activated Lullaby (P.A.L)
Model # PAL-HOS, including cables,
than the recommended separation
distance calculated from the
Page 27 of 30
500055 Rev E
Advertisement
Table of Contents
