Chapter 4: Operation; Preparation For Use - NeoLight Pacifier Activated Lullaby Instructions For Use Manual

Chapter 4: Operation

4.1 Preparation for Use

1. Remove the PAL Player from the packaging.
2. The PAL Player can be powered from the supplied wall power supply which is converted to DC
or 4 C cell alkaline batteries.
3. To install the batteries, turn the unit over
and remove the battery door. Install the
batteries observing correct polarity as
shown in the figure below. Replace the
battery door and turn unit back over.
Note: When batteries are exhausted,
discard in accordance with local
regulations.
4. To use the wall supply, connect the DC plug on the power supply to the DC input jack on the
side of the PAL Player as shown in the figure below. Plug the unit into the wall outlet.
5. Remove a PAL Sensor from its packaging
and uncoil the cable. Attach Phillips
Soothie / NICU Soothie / Wee Soothie /
Super Soothie pacifier to the PAL Sensor
as shown below. Ensure that the back of
the pacifier is flush against the face of the
PAL sensor.
6. Attach the PAL Sensor 3.5mm plug into
the jack on the side of the PAL Player as
shown in the figure below.
CAUTION: Ensure that the PAL Sensor with the pacifier is plugged into the PAL Player
before powering up the device for accurate calibration and functionality.
7. The PAL Player comes with an SD card installed with prerecorded lullabies. The SD card port is
in the back of the unit as shown above. Check that the SD card is fully inserted. The PAL Player
also has the capability to play recorded MP3's from a standard USB flash drive. To use the USB
port, insert the USB flash drive into the USB port on the side of the unit shown above.
© 2023 by NeoLight LLC.
All rights reserved.
Page 13 of 30
500055 Rev E