Destination; Complete Set; Device Arrangement - Electrolux EWH 30 V EEC User Manual

6
www.home-comfort.com
Warning!
The installation of the supplied safety valve
is a mandatory requirement. Do not install
any shut-off valve between the safety valve
and the and the tank inlet, as well as block-
ing the discharge port of the safety valve.
• Do not leave a water heater filled with
water without power and heating water
in a room where the temperature may be
below 0 °C.
• In case of long absences, repair, tech-
nological and preventive work on the
water supply line, it is necessary to close
individual stop valves on the cold water
supply line to the water heater and on the
hot water outlet line, as well as to turn off
the water heater and disconnect from the
power supply by pulling the plug from the
socket.
• If any part of the water heater is damaged,
contact a service technician for repair. Use
only replacement parts supplied by the
manufacturer.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of life experience or knowledge,
unless they are supervised or instructed.
Children should be supervised to ensure
that they do not play with the appliance.

Destination

The electric storage water heater is designed
for heating cold tap water. It is used exclu-
sively
The water from the water heater is not intend-
ed for drinking or cooking.
Installation and initial start-up of the heater
must be carried out by a qualified technician,
who can be held responsible for the correct
installation and give recommendations on the
use of the heater.
Wiring must comply with current standards
and regulations.
Before installing the water heater, make sure
the grounding electrode of the outlet is prop-
erly grounded. If the grounding electrode is
missing. The water heater must be grounded
by a separate grounding conductor to the
ground terminal on the heater element flange
fastener in the outlet. Do not install or operate
the product if grounding is not available.

Complete set

The electric storage water heater is complete
with the basic elements for installation and
connection. The water heater set includes:
• water heater with power cord — 1 pc;
• safety valve — 1 pc;
• fixing anchors for mounting.For 30L,
50L — 2 pcs; for 80L, 100L — 2 pcs;
• user manual — 1 pc;
• warranty card (in the manual) — 1 pc.

Device arrangement

1. Hull
2. Heating element
3. Power cord
4. Cold water inlet
5. Hot water output
6. Control Panel
7. Hot water supply pipe
8. Magnesium anode
9. Safety thermostat
10. Cold water intake pipe into the tank
(with diffuser)
11. Thermal insulation
Automatic water temperature control:
When you open the hot water tap on the
mixer tap at the water heater outlet, cold
water starts flowing in. The water in the tank
mixes and its temperature decreases. The
thermostat sensor reacts to the falling water
temperature and the heating element (heating
element) switches on automatically and heats
the water up to the set temperature. When the
temperature reaches the set point, the heating
element is automatically switched off.
Fig. 2