Operation; Installation Dimensions And Dimensions - Electrolux EWH 30 V EEC User Manual

Operation

Filling with water
In order to fill the tank completely with water,
it is necessary:
• open the hot water tap on the faucet;
• open the water supply valve to the water
heater;
• wait for the water to come out of the fau-
cet;
• close the hot water tap on the faucet and
make sure there are no leaks.
If water flows from the hot water tap — the
tank is full of water. Only then can the tank be
connected to the power grid.
In the case of uncertainty as to whether there
is water in the water heater, do not connect it
to the mains.
Connecting to the power grid
Watch out!
Connect to the mains only after filling with
water (the opposite may cause burning of
the heating element and damage to the
device).
Plug the water heater into an outlet, then the
on the panel lights. This indicates that the
water heater is switched on and is supplied
with power. Set the desired water heating
level from low to high using the heating tem-
perature control. Heating water is switched
off automatically when the set temperature is
reached and is switched on to reheat auto-
matically. When the water temperature reach-
es the set temperature, the heating will stop.
Installation dimensions and
dimensions
A, mm Ø340
B, mm 638
C, mm Ø300
D, mm 365
E, mm 205
ENGLISH
Fig. 6
Ø380 Ø450 Ø450
755 828 983
Ø300 Ø300 Ø300
405 475 475
205 205 205
9