Table of Contents
Advertisement
i OPERATION RANGE
You must point the remote control unit toward the РОМ
and be within
about 7 meters (23 feet) for proper operation.
29
REMOTE CONTROL sensor
TO PLAY A PROGRAM SOURCE
1. Press the POWER switch to turn the unit ON.
2. For video sources, turn the TV monitor ON.
3. Select the program source to be heard or watched with the INPUT
SELECTOR button.
@ When the sound of a video source is selected, the picture of that
video source is automatically selected. If you wish to watch
something other than it, press the PICTURE SELECTOR button to
select the desired picture.
@ When only the sound of a video source is desired, press the
PICTURE SELECTOR button until none of the PICTURE indicators
is lit.
4, Play the program source.
5. Adjust the VOLUME control to increase or decrease the output volume
level of all of the speakers.
6. Adjust the BASS, MID, and TREBLE tone controls for the
corresponding frequency response.
7. Set the BASS EXTENSION switch. Setting this switch to ON boosts the
low frequency response of the amplifier.
8. To use the Surround Processing mode, press the SURROUND
PROCESSING
MODE button and adjust the rear speakers level with
the VOLUME REAR LEVEL keys on the remote control transmitter.
When this unit drives a 5-speaker system, adjust the center speaker
level with the CENTER LEVEL control.
For details on the surround processing mode, refer to "THE
SURROUND PROCESSING МОРЕ" described later.
9. Adjust the VIDEO ENHANCER buttons for a video source. For details
on the video enhancer, refer to "USING THE VIDEO ENHANCER"
described later. ·
|
|
® Use the MUTING key оп the remote control transmitter to lower the
overall system volume to the -20 dB level. This lets you lower the
volume (to answer the phone, for example) without disturbing the main
volume setting.
Advertisement
Table of Contents
