Table of Contents
Advertisement
Ш TV/MONITOR
Connect the video input jack from the first TV/Monitor to the MONITOR
OUT 1 jack, and connect the video jack from a second TV/Monitor to the
MONITOR OUT 2 jack on the rear panel of this unit. Note that audio
output connections to the monitor are not necessary, as the audio portion
of the signal is sent to your speakers through the amplifier.
@ When a monitor that has an S video connector is used connect the S
VIDEO MONITOR OUT 1 connector. With the S VIDEO connections, a
high resolution picture will be obtained, resulting in much clearer
reproduction.
17
TV/Monitor having
S connector
Is connector
Video input jack\ пп.
DV — COV/Lv
— TV.
—
TAPE 2am
COLE Ds СОУЛ
ту
aT
m
WARNING: тозеснсе tHe а сх oF rie с стас
Second TV/Monitor
| Video input jack
SHOT 32 NOT EXPOSE "MS APPUANCE TO RAN TE
Ш OTHER VIDEO SOURCE
If necessary, you can connect a third video input source, such as a
camera, to the AUX jacks on the front panel of this unit. When connecting
a mono audio source, connect it to the L jack.
SPEAKERS
You can connect two pairs of speakers to this unit.
Follow these points to make the proper SPEAKERS A and SPEAKERS B
terminal connections.
When connecting the speaker terminals to your pees use the
proper gauge wire, cut as short as possible.
Make sure that the polarity of the speaker wires is correct, that is, that
the + and — markings are observed. If these wires are reversed, the
sound will be unnatural and will lack bass.
Do not coil up any excess speaker wire or bundle the speaker cables
with the power cords.
Strip approximately 3/8" (10mm) of the insulation from the speaker
. cords (whatever their gauge).
Advertisement
Table of Contents
