Creating Your Own Program (Program Play) - Sony MDS-302 Operating Instructions Manual

16
Playing MDs
ee
Creating Your Own Program
(Program Play)
You can specify the playback order of the tracks on an
MD and create your own programs containing up to 25
tracks.
C> PLAY MODE
PROGRAM
Number
buttons
CLEAR
</P>
MINIDISC RECORDER :
1 Press PLAY MODE repeatedly (or PROGRAM once)
until "PROGRAM" appears in the display.
2 Doeither a) or b):
a) When using the remote
Press the number buttons to enter the tracks you
want to program in the order you want.
To program a track with a number over 25, use
the >25 button (see page 14).
If you've made a mistake
Press CLEAR, then press the right number button.
b) When using the controls on the recorder
1 Turn AMS until the track number you want
appears in the display.
2 Press AMS or PLAY MODE.
3 Repeat Step 2 to enter other tracks. Each time you
enter a track, the total program time is added up
and appears in the display.
4 Press > to start Program Play.
To cancel Program Play
Press PLAY MODE repeatedly (or CONTINUE once) until
"PROGRAM" disappears.
Q You can program the same track repeatedly
While the track number appears in the display, press AMS
as many times as you want.
¢ The program remains even after Program Play ends
When you press D>, you can play the same program
again.
Note
The display shows "- - - -" instead of the total playing time
when the total playing time of the program exceeds 100
minutes.
Checking the track order
You can check the order of tracks in your program
during playback or playback pause.
Turn AMS (or press kK or PPI) during playback or
playback pause. The track numbers appear in the order
they were programmed.
Changing the track order
You can change the order of the tracks in your program
before you start playing.
To Do the following:
Erase the last track in the
program
Press CLEAR. Each time you
press the button, the last track
will be cleared.
Add tracks to the end of the
program
Do the procedure on this
page starting from Step 2
1 Press W (stop) while the
recorder is stopped.
2 Do the procedure on this
page starting from Step 2.
Change the whole
program completely