Notes On Recording - Sony MDS-302 Operating Instructions Manual

Recording on MDs
Rear of the disc
Record-protect tab
| Slide the tab in :
(the direction of arrow }
If "Protected" appears in the display
If "Din Unlock" appears in the display
e The program source is not connected to DIGITAL IN even
though you've selected DIGITAL in Step 4 or the sampling
frequency of the program source does not match that of the
MD recorder (44.1 kHz). To continue, connect the program
source through DIGITAL IN or select ANALOG in Step 4 to
record through LINE IN.
The digital signal has been interrupted (stopped) while you
were recording. To continue recording, restart the digital
program source. To stop recording, press ll on the MD
recorder.
Depending on source being recorded, track numbers are
marked in the two following ways:
e When recording from a CD or MD with INPUT at DIGITAL
and the source connected to DIGITAL IN, the recorder
automatically marks track numbers in the same sequence as
the original. However, if a track is played more than once
(i.e., by repeated playback during program play or single-
track repeat play), the same track is recorded as a single
track no matter how many times it is played.
If the source is an MD, track numbers may not be marked for
tracks of less than 4 seconds.
If "TRACK" flashes in the display
When "TOC" flashes in the display
MDs recorded through DIGITAL IN cannot be copied onto
other MDs through DIGITAL IN.