Advertisement
7. Troubleshooting
The dishwasher has an autodiagnosis system capable of detecting and
indicating a preset series of possible malfunctions.
TABLE OF MALFUNCTIONS DETECTED BY THE AUTODIAGNOSIS SYSTEM
FAULT
Error 01
Anti-flooding system tripped (where installed).
Error 02
The system that limits the water level in the dishwasher has been tripped.
Error 03
The dishwasher is unable to heat the water.
Error 04
Temperature sensor disconnected.
Error 05
The dishwasher is unable to fill with water
Error 06
The dishwasher is not able to pump out the water from the tank.
The dishwasher is not able to measure the amount of water loaded
Error 07
accurately.
Error 08
Anomaly in the system which distributes water to the baskets.
Error 09
Water intake system malfunction.
Error 11
Washing pump failure
If an alarm occurs, the machine stops the current program and indicates the fault.
Alarms E1 and E11 require you to contact the technical assistance service.
Alarm E7 is displayed at the end of the cycle, which is anyway completed, as it
does not affect the operation of the dishwasher.
For all other alarms, proceed as follows: stop the current program, switch off the
dishwasher. Switch on and program the dishwasher again to start the new wash cycle.
If the malfunction persists, contact your authorised Service Centre and
provide it with the fault code.
The contact details of the Technical Assistance Department can be found
on the warranty certificate and the website
The manufacturer reserves the right to make any changes deemed necessary for the
improvement of its products without prior notice.
User instructions
DESCRIPTION
57
Advertisement
Troubleshooting
