Table of Contents
Advertisement
Available languages
Available languages
1
KEY
The following symbols have been used in the discussion:
WARNING, GENERAL DANGER.
Failure to respect the instructions that follow may cause harm to persons and property.
WARNING, ELECTRICAL DANGER.
Failure to respect the instructions that follow may cause a situation of grave risk for personal safety. Take care not to come
into contact with electricity.
Notes and general information. Please read the following instructions carefully before operating and installing
the machine.
DAB Pumps makes every reasonable effort to ensure that the contents of this manual (e.g. illustrations, texts and data) are accurate,
correct and up-to-date. Nevertheless, they may not be free of errors and may not be complete or up-to-date at any time. The company
therefore reserves the right to make technical changes and improvements over time, even without prior notice.
DAB Pumps accepts no liability for the contents of this manual unless subsequently confirmed in writing by the company.
2
PUMPED LIQUIDS
The machine has been designed and made for pumping water, free from explosive substances and solid particles or fibres, with a
density of 1000 Kg/m³, a kinematic viscosity of 1mm²/s and non chemically aggressive liquids.
3
GENERAL
3.1
Product name
AQUAFRAME
3.3
Description
The AQUAFRAME is used to manage the levels and distribution of rainwater or hybrid water (rainwater and mains water) collected in
a special hybrid tank. The unit detects the lack of water in both rain water and mains collection system and corrects it to guarantee
that the system operates correctly (or rather, it never lets the identified users run out of water). Notify in the event of faults and indicate
the type of problem incurred. The system is generally used for supplying utilities with non-drinking water such as washing machines,
toilet discharge and floor-washing or irrigation systems.
3.4
Specific product references
For technical data, refer to the technical data plate or the dedicated chapter 11 TECHNICAL DATA at the end of the manual, if available.
4
WARNINGS
Check that all the internal parts of the product (components, leads, etc.) are completely free from traces of humidity,
oxide or dirt: if necessary, clean accurately and check the efficiency of all the components in the product. If necessary,
replace any parts that are not perfectly efficient.
It is indispensable to check that all the product leads are correctly tightened in the respective clamps.
Some functions might not be available, depending on the software version.
4.1
Live parts
Refer to the Safety Booklet (code 60183268).
4.2
Product disposal
This product or its parts must be disposed of according to the instructions in the WEEE disposal sheet (cod. 60187286) included in the packaging.
5
MANAGEMENT
5.1
Storage
-
The product is supplied in its original pack in which it must remain until the time of installation.
-
The product must be stored in a dry covered place, far from sources of heat and with possible constant air humidity, free from
vibrations and dust.
-
It must be perfectly closed and isolated from the outside environment, so as to avoid the entry of insects, humidity and dust which
could damage the electrical components, jeopardizing their regular operation.
ENGLISH
3.2
Classification according to European Reg.
BOOSTER
11
Advertisement
Chapters
Table of Contents
