Projecta IQD2 Manual page 11

ERROR ERROR TYPE ERROR DETAIL
SOURCE
INTELLI-IQ FIRMWARE
UPDATE
OVERHEAT
DEVICE ERROR
AUXILIARY SHORT CIRCUIT
BATTERY
OVERVOLTAGE
REVERSE
CONNECTION
FAULTY BATTERY The battery is faulty and does not work well after charging.
NO BATTERY
CONNECTED
ALTERNATOR OVERVOLTAGE
INPUT
REVERSE
CONNECTION
SOLAR INPUT OVERVOLTAGE
REVERSE
CONNECTION
IDCX OVERHEAT
LOW VOLTAGE
& CRITICAL LOW
VOLTAGE
The system is updating its firmware. Please do not turn off any
device in the network and wait until the process is complete.
This process may take up to 15 minutes for a major update that
includes a graphic library update.
The system is overheating and will shut down soon to protect
itself. Please let the device cool down before using it again.
A connection problem has occurred on the LIN network. Please
check the hardware connections and wait for IQD2 to detect the
network automatically. This process takes about one minute.
The auxiliary battery has a short circuit problem. Please fix the
issue before the battery gets damaged.
The battery voltage is over 16.5V, which is too high. Please check
the battery pack setup. The charging system will stop charging if
the voltage is above the limit.
The auxiliary battery is connected in the wrong way, which can
harm other devices. Please disconnect and check the battery or it
will not be charged.
Please replace the battery in the system.
The charging system cannot detect an auxiliary battery.
Please make sure the connection is secure.
The alternator input voltage is too high and exceeds the limit
of 32.5V, which stops the charging process. Please remove and
make sure the source voltage is within the operating range.
The alternator input is connected in the wrong way, which can
damage the charging system. Please disconnect and inspect the
input to avoid any harm.
The solar input voltage is too high and exceeds the limit of 32.5V,
which stops the charging process. Please remove and make sure
the source voltage is within the operating range.
Solar input is connected in the wrong way, which can damage
the charging system. Please disconnect and inspect the input to
avoid any harm.
The charging system is affected by high ambient temperature,
which reduces the charging performance. The charging process is
still continuing within a safe range.
The supply voltage is not enough to charge the battery. Please
check the input source, such as the alternator or the solar panel,
to ensure they provide enough voltage to start the charging
process.
11