Checking The Battery Charge Level; Fitting The Additional Handle; Changing Tools; Torque Preselection/Selecting The Operating Mode - Parkside 302117 Instructions Manual

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting the additional handle

♦ Screw the additional handle
right of the appliance depending on how you
work.

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . Once you have attached the desired tool
and tightened it by turning the chuck
continue working. The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed).
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque preselector
and select between the drill setting and the
hammer drill setting
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
♦ Select the hammer drill setting for hammer
drilling work by adjusting the torque selection
ring to the position

2-speed gearbox

CAUTION!
► Operate the speed selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
PSBSA 20-Li B2
to
as follows:
onto the left or
, you can
.
.
only
In first gear (speed selector switch
position: 1)
you can reach a speed of approx. 440 rpm and a
high torque. This setting is suitable for all screwing
work but also for the use of accessories.
In second gear (speed selector switch
position: 2)
you can reach a speed of approx. 1650 rpm for
carrying out drilling work.

Use

Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED work light
OFF switch is depressed lightly or fully. This
allows for illumination of the work area in low
lighting.
Switching off:
♦ Release the ON/OFF switch
appliance.

Adjusting the rotational speed

Press the ON/OFF switch
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotational direction switch
or right.

Tips and tricks

Tip! This symbol indicates proper
behaviour.
♦ Before operating the appliance, check whether
the screw or drill bit is correctly positioned, i.e.
centred in the drill chuck.
in
lights up when the ON/
to switch off the
lightly for a low
towards the left
GB │ IE │ NI │ CY │
in
7 ■