Etekcity EK7090 - Digital Kitchen Scale Manual

Specifications

Function Diagram

1. Unit Selection Button
2. LED Display
3. Power/Tare Button
4. Anti-Skid Pads
5. Battery Compartment

Before First Use

The batteries are pre-installed in the scale.

1. Turn the scale over and open the battery compartment.
2. Remove the plastic strip from the battery compartment. [Figure 1.1]
   
   Figure 1.1
   
3. Replace the battery compartment cover.
4. Turn the scale over again and place on a hard, dry, flat surface.
5. Tap to turn on the scale.

Using Your Scale

Note:

• For accurate results, always place the scale on a hard, dry, flat surface, and keep the scale away from dirt, dust, vibrations, wind, air currents, and electromagnetic interference.
• When you turn on the scale, choose units, or use the tare function, wait for the scale to read " " again before measuring.

General Operation

1. Place the scale on a hard, flat, level surface for measurement.
2. Tap to turn on the scale. Make sure the scale shows " ". Tap to select your desired measuring unit, which will show on the right of the display.
3. Place your item on the scale.
4. Wait for the reading on the display to stabilize.

Unit Conversion

To change the unit of measurement, tap until the display shows the desired unit of measurement.

Automatic Power Off

To save battery power, the scale will automatically power off after 180 seconds of inactivity.

Manual Power Off

Press and hold for 2 seconds to turn off the scale.

Zero / Tare Function

Whenever you measure items inside a container, you can use the tare function to remove the container's weight from the final measurement.

1. Tap to turn on the scale. Make sure the scale shows " ". If the screen does not display " " automatically, tap to auto-adjust to zero.
2. Place the container on the center of the scale.
3. Wait for the reading on display to stabilize. The screen will display the container's weight.
4. Tap to tare the weight of the container. The screen should now display " ".
5. Place the item in the container. The scale will measure the liquid or items, without including the weight of the bowl.
   [Figure 2.1]
   
   Figure 2.1
6. When you're done, reset the scale by removing all weight and tapping again.

Replacing the Batteries

1. Turn the scale over and open the battery compartment.
2. Take out the used batteries and replace them with 3 new 1.5V AAA batteries.
3. Replace the battery compartment cover.

Troubleshooting

Problem	Possible Cause
Scale does not turn on.	Open the battery compartment cover and remove the plastic strip.
	Replace the batteries.
	Make sure batteries are inserted under the correct polarity as marked on battery compartment.
Reading is inaccurate.	Place scale on a level surface.
	Make sure the screen displays " " before measuring (see Zero / Tare Function).
	Remove the batteries for 45 seconds, then replace them to reset the scale.
Display shows " "	Item is too heavy. Remove item from scale to protect its weight sensors. Use a different scale with a higher weight range.
Display shows " "	Turn the scale off and on again. Avoid moving the scale while measuring.
Display shows " "	Battery power is low. Replace the batteries.

If your problem is not listed, please contact Customer Support.

Customer Support

If you encounter any issues or have any questions about your new product, please contact our helpful Customer Support Team. Your satisfaction is our goal!

Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806

Email: support@etekcity.com
Toll-Free: (855) 686-3835

SUPPORT HOURS
Mon–Fri, 9:00 am–5:00 pm PST/PDT

*Please have your order invoice and order ID ready before contacting Customer Support.

Important Safety Information

READ AND SAVE THESE INSTRUCTIONS

To avoid damage to this scale, please read and follow all instructions and safety guidelines in this manual.

Scale

• Do not exceed the 11 lb / 5000 g weight capacity as it will damage the scale. An error indicator will appear on the LED display if the limit is exceeded.
• Do not immerse the scale in water or any liquid. If liquid is spilled on the digital display or buttons, immediately wipe the scale clean with a soft cloth to avoid internal damage.
• Handle with care. This scale is not intended for commercial or heavy-duty use.
• Keep the scale in a cool, dry place. Avoid exposure to damp environments or extreme temperatures.
• Household use only.

Batteries

• Do not mix new and old batteries.
• If the low battery indicator ("Lo") appears on the display, replace the batteries.
• If the scale is not in use for an extended period of time, remove the batteries to conserve battery life and extend the lifetime of the scale.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Etekcity EK7090 - Digital Kitchen Scale Manual