Sony PS-FL1 Service Manual page 7

PS-FL1/FLIC PS-FL1/FLIC
AUTO PLAY
CONNECTIONS
@ Turn off the amplifier before making connections.
To play a 45 rpm record,
depress.
Rear view of amplifier
= a
i Phono cord = j
White... to ie |
to an ac outlet
automatically return to the arm rest and the turntable will stop. e@Turn off the POWER
switch after the tonearm returns to the arm
RECORD PLAYING
TO BEGIN RECORD PLAY AT A PARTICULAR POINT—Manual play
PREPARATION
@ Place a record on the platter. For 17 cm (7 inch) records, put the
supplied 45-rpm adaptor over the center spindle.
@ Lower the amplifier volume and set the input selector to PHONO.
:
Bring the tonearm to the point
Follow the numbered sequence
————
over the record at which you
j \ want play to begin.
Turn on
the power. 2 Set the input selector
The module will close, the LIFTER button.
tonearm will lower onto the
record and play will begin.
Amplifier
Turntable system
45-rpm adaptor
pleuppIied)
To play a 45 rpm record,
Transparent records and 25 cm (10 in.) depress.
records cannot be played automatically.
Play them manually, following the
instructions on page 12.
Press the OPEN/CLOSE button to open the module.
If you lower the tonearm too near the record label, the auto return module.)
mechanism may not activate at the end of the groove. This is You can stop play by pressing the START/STOP button instead of
because the tonearm reaches the end of the record before the auto the OPEN/CLOSE button. In this case, the module will not open.
return detector can activate. 3
, TO REPEAT PLAY
TO LIFT UP THE STYLUS DURING PLAY Depress the REPEAT button either before or after starting play. The
To iift the stylus from a record for a moment and then start playing
tonearm continues repeat play unless the button is pressed again
from the same point, press the ARM LIFTER button. To lower the
to turn off the repeat function. To stop during repeat play, press to
tonearm onto the record, press the button again.
release the REPEAT button, and press the START/STOP button.
—-11— —12—