Table of Contents
Advertisement
SECTION 2
PS-FL1 /FL1C
DISASSEMBLY
Note:
Follow the disassembly procedure
in the numerical order given.
2-1.
NOTE
ON
TURNING
SET UPSIDE
DOWN
1. Remove the turntable.
2. Lock the arm in the arm rest.
3. If the set is turned over carelessly, the tonarm may
bend.
Proceed as follows:
1) With the bottom plate attached, the module is
supported by the guide plate, as shown in the
figure below.
bottom plate
ponent
module
section
top plate
2) If the bottom plate is removed at this point,
the module
will drop. So, the weight of the
front of the module
will fall on the tonearm
cartridge section and bend the tonearm.
2-2.
REMOVAL
3) In order
to prevent
this, proceed
as shown
below.
Grasp so that sections
top plate
and (B) do not come
apart, and turn upside down.
bottom plate
Position a support to prevent
the set from falling over.
CONTROL
PANEL,
CONTROL
BOARD,
SW (A) BOARD,
POWER
SW BOARD
power sw board
panel reinforcement
:
_
control pete
a
<n
control OSs
=e
panel
™~
BV3x8
BV3x8
B3x8
BV3x 8
-21—
-PS-FL1/FLIC
TOP PLATE
fixed screw
top plate reinforcement
TURNTABLE,
TURNTABLE
SHEET,
RECORD
SENSOR
(A) BOARD
— When the module does not slide —
@,@ : turntable, turntable sheet
OsviT3x6
@ reinforcement
turntable sheet
turntable
top plate
TURNTABLE,
TURNTABLE
SHEET
— When the module slides —
turntable sheet
turntable
@ Push the POWER
button.
;
module
@ Touch the OPEN
button.
—22—
Advertisement
Table of Contents
