Yoer FH02W BLOWER Manual page 35

c) Oscillation setting: Press
the button again to turn it off.
d) Time settings:
 Delayed shut-off:
When the appliance works click
(within a range of 0,5-24 hours).
Wait until icon
counting down the time until the end of work.
If you want to turn on the timer, press the button
from the display.
 Delayed switch-on:
When the appliance is in stand-by mode click
to set the timer (within a range of 0,5-24 hours).
Wait until icon
counting down the time to start working.
When the programmed time has been reached, the appliance turns on at the low heating
power with the previously set temperature.
If you want to turn on the time delay, press the button
disappears from the display.
CAUTION:
A thermal overload protector is built in to the heater to prevent overheating. When an overheat
temperature is reached, the heater will be automatically shut off. It can only resume operation
when the user resets the unit. To reset the heater unplug it and wait 5-10 minutes for the unit
to cool down. Then plug the unit in again and operate normally.
The fan heater has also a tip-over protection that switches the device off automatically when
the device falls over.
ENGLISH
button once to turn the oscillation function on and press
button, then press
stopped flash, then the time will be set and the device will start
stopped flash, then the time will be set and the device will start
or
twice until the icon
button, then press
35
button to set the timer
disappears
or
twice until the icon
button