LG KCHH Series Installation Manual page 67

Classification
Start/Stop
Heating/Cooling
Cooling setpoint
temperature
Heating setpoint
temperature
Load outlet water
temperature
Control mode
Remote mode
Central control address
Maximum operation
frequency
Capacity of product
Version
Screen display
(1 Level)
Set RUN to operate the product and STOP to stop the
RUN/STOP
operation.
Sets the product's cooling/heating operation mode.
HEAT/COOL COOL selects cooling mode and HEAT selects heating
mode.
Sets cooling target temperature.
7
(ACAH/ACHH : 4 °C ~ 20 °C (39.2 °F ~ 68 °F))
(KCHH : 4 °C ~ 25 °C (39.2 °F ~ 77 °F))
Sets heating target temperature
45
(ACAH/ACHH : 30 °C ~ 55 °C (86 °F ~ 131 °F))
(KCHH : 30 °C ~ 60 °C (86 °F ~ 140 °F))
Shows the temperature value of load outlet water.
-
(Specified in 0 level)
Set's the product's control mode. In LOC, the product
control is available with HMI and Chiller controller.
LOC/DIST/SCHE DIST refers remote control mode. In SCHE, the
product is controlled following the schedule set at
HMI.
Sets how to set in remote mode. CONT enables the
product's operation mode by simple switch contacts.
CONT/BUS
BUS enables the control on the entire product through
communication from other communication devices.
The product address can be set for communication
with other communication devices. The address can
1
be set by selecting values from 1-246.
Enter a hexadecimal value between 1 and 246.
Sets the maximum operation frequency.
110
(ACAH Series: 70Hz~126Hz,
ACHH/KCHH Series: 70Hz~120Hz)
Shows the current capacity of product.
-
(Specifies in 0 level)
Shows the program information of Chiller controller
installed in the current product as version. Version
- information is subjected to change for improvement of
the product performance or the quality improvement.
(Specifies in 0 level)
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
OPTIONAL SETTINGS
Detail description
67