Mitsubishi Electric 800 Series Instruction Manual page 10

Symbol Name
a Mounting hole
b Terminal block
c Switch for thermistor calibration (SW2)
d Switch for manufacturer setting (SW1)
e Switch for manufacturer setting (SW3)
f Switch for manufacturer setting (SW4)
g Board mounted option connector
10
PRE-OPERATION INSTRUCTIONS
Description
Used to fix this product to the inverter by inserting a mounting screw or a
spacer.
Wire the input or output devices.
Change the setting when calibrating the thermistor.
Do not change the switch setting from the initial setting. (
Do not change the switch setting from the initial setting. (OFF
Do not change the switch setting from the initial setting. (Switches 1 and
2 are ON .)
Used to connect this product to the option connector on the inverter.
Refer to
page
12
16
41
―
)
―
)
―
12