Philips AQUA 8000 Series Manual page 15

Problem
Too much water flows out
of the water tank at a too
high speed.
The floor dries with stripes
when I use the water tank.
Possible cause
If too much water flows out
of the water tank at a too
high speed, the cap of the
tank is probably not closed
properly.
The strip is not placed
properly in the bottom of the
water tank.
You pushed the Aqua Boost
pedal too often.
You added too much liquid
cleaner to the water.
Solution
Check the cap and make sure it is fully
and properly closed.
Check the strip and make sure that it is
fitted properly in the bottom plate of the
water tank.
Push the Aqua Boost pedal (Fig. 4) only
once each time and check after each
time if you have achieved the wetness
level you want.
Use only a few drops of liquid cleaner or
use a cleaner that foams less.
English
17