Display icons and their meaning______________________________________________________________ Replacement ______________________________________________________________________________ Troubleshooting ___________________________________________________________________________ Introduction Thanks for buying this Philips product! To fully benefit from the support that Philips offers, register your product at www.philips.com/MyAquaTrio7000s General description 1 On/off button 2 + and - buttons...
Page 7
English Note: Make sure that the After-Clean tray is placed in the baseplate and that the temperature in the room where the appliance is stored, charged and cleaned is between 5 °C and 35 °C. Note: you can store the cleaning brush in the After-Clean tray as well. 1 To assemble the appliance, insert the handle into the main body ('click').
English Charging The appliance is equipped with a 25 V Li-Ion battery. Charging takes 4 hours. 1 To charge the appliance, open the sealing cap on the back of the appliance. 2 Insert the power plug into the socket on the back of the appliance. Then insert the adapter into the wall socket.
English Tip: You can charge the appliance in the After-Clean & Storage station. Tip: You can charge the appliance separately in a place that suits you best. Vacuuming and mopping hard floors Using the appliance The clean water tank and the dirty water tank are already attached to the appliance upon delivery.
Page 10
English 3 Add 15 ml of the XV1792 Philips Floor Cleaner to the clean water tank. Caution: Philips has only tested this appliance with XV1792 Philips Floor Cleaner. Other detergents may lead to excessive foaming, which reduces performance and may cause the appliance to malfunction.
Page 11
English 7 Take the appliance out of the After-Clean & Storage station and place it on the floor. Put your foot on the AquaSpin nozzle and pull the handle backwards to unlock the AquaSpin nozzle. The appliance is now ready for use.
Page 12
If you want to add a liquid floor cleaner other than XV1792 Philips Floor Cleaner to the water in the clean water tank, make sure that you use a low- foaming or non-foaming liquid floor cleaner that can be diluted in water like XV1792 Philips Floor Cleaner.
Page 13
English Cleaning the appliance AUTOCLEAN after every use To prevent odors and scale deposits, use the AUTOCLEAN function after every use. The AUTOCLEAN mode helps you to clean your full appliance in approximately 4 minutes. 1 Place the appliance in the After-Clean & Storage station. Slide the appliance on to the appliance holder so that the end of the appliance holder sticks into the appliance.
Page 14
English 4 Pour the water out of the dirty water tank into the sink. 5 Place the wet filter back on the dirty water tank. 6 Fill the clean water tank if the water level is below the AUTOCLEAN indication. Otherwise, you can skip the following steps and move forward to step 12.
Page 15
English 9 Fill the clean water tank with cold or lukewarm tap water at least up to the AUTOCLEAN indication. Caution: The tap water that is poured into the clean water tank must not be warmer than 50°C. Caution: Do not use detergent for the AUTOCLEAN as this might lead to excessive foaming.
Page 16
English 13 To start the AUTOCLEAN cycle, press the AUTOCLEAN button. If you see a black screen, press the on/off button first to activate the screen. 14 The appliance performs the AUTOCLEAN cycle. Note: The Autoclean cycle lasts approx. 4 minutes. For best results, let the appliance run through the AUTOCLEAN cycle completely.
Page 17
English 18 Clean the dirty water tank under the tap. 19 Clean the wet filter under the tap. 20 Let the wet filter of the dirty water tank and its water flow element dry completely before putting it back on the dirty water tank. 21 Place the wet filter back on the dirty water tank.
Page 18
English 23 Turn the microfiber brushes counterclockwise (1) and remove them from the AquaSpin nozzle (2). Tip: In case a microfiber brush is difficult to remove, you can use the cleaning brush handle to unlock the microfiber brush. 24 To allow the microfiber brushes to dry, place the open ends of the brushes on the designated holders of the After-Clean &...
Page 19
English Cleaning the AquaSpin nozzle 1 Turn the microfiber brushes counterclockwise (1) and remove them from the AquaSpin nozzle (2). Tip: In case a microfiber brush is difficult to remove, you can use the cleaning brush handle to unlock the microfiber brush. 2 You can remove entangled hair or threads from the microfiber brushes by sliding down the microfiber brushes with one hand.
Page 20
English Clearing blockages from the AquaSpin nozzle If there is a blockage in the AquaSpin nozzle, remove the brushes from the nozzle. Then move the cleaning brush up and down in the suction channel of the AquaSpin nozzle. Clearing blockages from the wetting strips of the AquaSpin nozzle After long and frequent use of the appliance, the wetting strips of the AquaSpin nozzle may become clogged at some point.
(near hot stoves, in microwave ovens, or on induction cookers). If the device is used and stored at the correct temperature and still shows the error code, please take it to a Philips service center or contact the Consumer Care Center.
Page 22
English Information code Cause Solution The dirty water tank is full. Empty the dirty water tank. The AquaSpin nozzle is stuck. Check the brushes, bearings, motor parts, This is a safety cut-off if and caps for hair or other obstacles and something is stuck in the nozzle remove them.
Replacement To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details). Replacement parts and type numbers:...
Page 24
English Problem Possible cause Solution You did not take the appliance Take the appliance out of the After-Clean & out of the After-Clean & Storage station before switching on the Storage station. appliance. You pushed the on/off Wait a few seconds and push the on/off button more than one time.
Page 25
If you have checked the above and there is still no water on the floor, take the appliance to a Philips service center or contact the Consumer Care Center. There is more water on the...
Page 26
AquaSpin nozzle. If you have checked the above and the appliance still does not clean well, take it to a Philips service center or contact the Consumer Care Center. Bigger dirt particles are not The water channel of the wet...
Page 27
There is a crack in one of the If one of the tanks is damaged, take it to a tanks. Philips service center or contact the Consumer Care Center. I cannot remove the Hair and/or dirt is entangled in Use the cleaning brush handle to remove microfiber brushes.
Page 28
(near hot stoves, in microwave ovens, or on induction cookers). If the device is used and stored at the correct temperature and still shows the error code, please take it to a Philips service center or contact the Consumer Care Center.
Need help?
Do you have a question about the AquaTrio Cordless 7000 and is the answer not in the manual?
Questions and answers