Philips AQUA 8000 Series Manual page 12

English
14
Signal Description of signal
Error code 'E7' lights up on the display.
Note: When the appliance is charging on the
charging station, the E7 error code may look like
the designation L3
Error code 'SE' lights up on the display.
Note: When the appliance is charging on the
charging station, the SE error code may look like
the number 35.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The appliance does not
work when I push the
slider.
The appliance has a lower
suction power than usual.
Possible cause
When the battery is empty,
the following icon flashes on
the display:
You have to push the slider
forward to switch on the
appliance.
The filter and the cyclone are
dirty.
You have not attached the
dust container lid properly to
the dust container or you
have not attached the dust
container properly to the
appliance. In both cases,
there will be a loss of suction
power.
Meaning of signal
The adapter may be defective.
Please contact the Consumer Care
Center or take the appliance to an
authorized Philips service center.
SE stands for service. Please take the
appliance to an authorized Philips
service center.
Solution
To charge the battery, connect the
appliance to the charging station or
attach the handheld vacuum cleaner
directly to the magnet on the charging
station (Fig. 11).
Push the slider forward to setting 1 to
switch on the appliance. Increase the
suction power further by pushing the
slider to setting 2 or select the Turbo
setting to clean very dirty patches at the
highest suction power.
Empty the dust bucket. Clean the filter
(Fig. 10) and the cyclone (Fig. 12). The
filter light lights up after several hours of
use to indicate that you have to wash
the sponge filter. Make sure that you
wash the sponge filter at least once a
month if you use the appliance regularly.
Make sure that you remove any hair and
dirt that is stuck in the cyclone.
Make sure that you attach the dust
container lid to the dust container and
the dust container to the appliance
properly.