JVC XV-S200BK Instructions Manual page 16

Getting started
You can enjoy high picture quality by connecting the unit's COMPONENT VIDEO OUT jacks to the COMPONENT VIDEO
IN jacks of your TV with the video cables.
Note that the COMPONENT VIDEO OUT jacks are not active in the initial (factory preset) condition. See below for details
how to make them active.
Blue
Component video cable
Green Red (not supplied)
The unit
White
Audio cable (not supplied) Red
Blue
Green _ --_Red
TV I I m
,,
VIDEO IV _'N _1
• Connect "Y" to "Y," "PB" to "Pa," "PR" to "PR" correctly.
Enabling the COMPONENT VIDEO OUT
For your "IV connection, you can use either the component video output or the S-video output at a time,
When you use the component video output, set the VIDEO OUT SELECT (COMPONENT/S-VIDEO) switch on the rear
panel to "COMPONENT', Then, "COMPONENT" appears on the display window for a few seconds,
(Display Window)
VCDVD GROUPTITLETRACK CHAP C__1A-B
O000B 01110 01110 I0001 III10 01110 IBO01 III10 IOOBI IIIII 00000 00000
O000B I0000 I0001 I1011 I0001 I0001 I1001 IBBBO IIOBI 00100 00000 00000
OOB I00 I01 I01 I01 I01 I01 IBO I01 DID 000 000
O000B I0000 I0001 I0101 III10 I0001 IBIOI III10 IOIBI 00100 00000 00000
Note that you must change the switch position while the unit is stopped, or the unit power is off. Otherwise, the changed
setting is not effective.
NOTE
• When the component video input jacks of the TV isthe BNCtype, use an adapter to convert a pin jack to a BNCjack (optional).
14