Product Description; Installation Procedure; Mounting Preparations - Vega VEGAWELL 52 Mounting Instructions

2 Mounting
1

Product description

1.1 Appropriate use
The screw connection for suspension cable is
used for installation and height adjustment of
the submersible pressure transmitter VEGA-
WELL 52.
2 Mounting
2.1

Mounting preparations

You will need suitable spanners for assembly.
You can find the required wrench size under "
Dimensions".
2.2 Mounting example
Abb. 7: Application example with submersible pressure
transmitter in a basin
6
2.3

Installation procedure

Abb. 8: Configuration, screw connection of suspension
cable
1 Suspension cable
2 Sealing screw
3 Cone bushing
4 Cone seal
5 Base element
6 Flat seal
Mount VEGAWELL 52 with screw connection
for suspension cable as follows:
1. Lower VEGAWELL 52 to the requested
height through the welded socket on the
vessel
2. Open the screw connection with a suitable
wrench (wrench size see chapter " Dimen-
sions") and push the suspension cable from
below into the base element
3. Slide the sealing cone and the cone sleeve
over the suspension cable, fasten manually
with the seal screw
4. First tighten the base element in the welded
socket with a suitable wrench, then tighten
the sealing screw
How to correct the height:
1. Loosen sealing screw
2. Slide cone seal and cone sleeve to the
requested position on the cable
3. Tighten the seal screw again
Disassembly is carried out in reverse order.
Warning:
Before dismounting, make sure that the-
re are no dangerous process conditions
such as e.g. pressure in the vessel or
high temperatures.
Screw connection for suspension cable •
1
2
3
4
5
6