Adjustment; Stopping The System - Daikin RXYQ6BRY16 Installation Manual

6.2 Adjustment

For adjustment the desired temperature, fan speed
and air flow direction (only for the remote controller,
follow the procedure shown below).
BRC1E62
2,3
Temperature adjustment
Press the temperature setting button
1
Each time this button is pressed, the
temperature setting rises or lowers 1°C.
NOTE
• Set the temperature within the operation range.
• The temperature setting is impossible for fan
only operation.
Explanation of heating operation temperature
adjustment
It may take longer to reach the set temperature for
general heating operation than for cooling operation.
The following operation is performed in order to
prevent the heating capacity from dropping or cold
air from blowing.
Fan speed and Air flow direction adjustment
Press air flow setting button
2,3
• To select air volume or direction setting,
press "
• With air volume selected,
using the "
• With direction selected,
using the "
(only for Double-flow, Multi-flow, Corner,
Ceiling-suspended and Wall-mounted).
01_EN_3P748230-1.indd 9
1
" buttons.
" buttons.
" buttons.
Movement of the air flow flap
Double-flow+multi-flow units
Corner units
Ceiling-suspended units
Wall-mounted units
For the following conditions, a microcomputer
controls the air flow direction which may be
different from the display.
COOLING
• When the room temperature is
lower than the set temperature.
• When operating continuously at horizontal air flow direction.
• When continuous operation with downward air flow is performed at
the time of cooling with a ceiling-suspended or a wall-mounted
unit, the microcomputer may control the flow direction, and then
the user interface indication will also change.
The air flow direction can be adjusted in one of the
following ways:
• The air flow flap itself adjusts its position.
• The air flow direction can be fixed by the user.
• Automatic " " or desired position "
NOTICE
• The movable limit of the flap is changeable.
Contact your dealer for details.
(only for Double-flow, Multi-flow, Corner,
Ceiling-suspended and Wall-mounted).
• Avoid operating in the horizontal direction
" ". It may cause dew or dust to settle
on the ceiling or flap.

6.3 Stopping the system

Press the ON/OFF button once again.
The operation lamp goes off and the system stops
operation.
NOTICE
• Do not turn off the power immediately
after the unit stops, but wait for at least
5 minutes.
• The system need at least 5 minutes for
residual operation of drain pump device.
Turning off the power immediately will
cause water leak or trouble.
HEATING
• When starting operation.
• When the room temperature is
higher than the set temperature.
• At defrost operation.
".
9
11/01/2023 16:40:16