Advertisement
Quick Links
Operation Manual
Copper Hatchet Tip Soldering Iron
62444
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 62444
Summary of Contents for WilTec 62444
- Page 1 Operation Manual Copper Hatchet Tip Soldering Iron 62444 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Never carry out the test near flammable materials or other people. • If the flame is blown out by a gust of wind, immediately close the gas-flap valve and gas-control valve to prevent further gas leakage. © by WilTec Wildanger Technik GmbH Item 62444 Page 3 http://www.wiltec.de...
- Page 4 An adapter with the following dimensions is required to use the pres- sure reducer: 20 mm BSPP ½″ external thread on the left, 13.16 mm BSPP ¼″×19 internal thread on the left (not included in the scope of delivery). © by WilTec Wildanger Technik GmbH Item 62444 Page 4 http://www.wiltec.de...
- Page 5 Overtightening the screws can damage the torch components. • Attach the hose to the mounted tool (Fig. 4) and the other end to the gas cylinder. © by WilTec Wildanger Technik GmbH Item 62444 Page 5 http://www.wiltec.de...
- Page 6 5. Place the tool on a non-flammable, heat-resistant, level, and flat surface and wait until the sol- dering tip has warmed up. 6. Place the tip on the soldering point. Make sure that the torch flame is only directed at the sol- dering tip. © by WilTec Wildanger Technik GmbH Item 62444 Page 6 http://www.wiltec.de...
- Page 7 Secure the tool during transport. Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 62444 Page 7 http://www.wiltec.de...