Display Assembly - HP 240R G9 Maintenance And Service Manual

Display assembly

To remove the display assembly, use this procedure and illustration.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove the display assembly:
1. Disconnect the display cable (1) from the system board.
2. Disconnect the wireless antenna cables (2) from the WLAN module.
3. Position the computer so it is open with the display (1) hanging off the table.
4. Remove the six Phillips M2.5 × 6.0 screws (2) from the display hinges.
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Rubber feet on page
Bottom cover on page
Battery on page 32).
30).
31).
30).