Cleaning The Filter Insert (In The Plinth); Removing The Filter Insert - Miele PDR 908 HP Operating And Installation Instructions

Cleaning the filter insert (in the
plinth)
The surface of the filter in the filter in-
sert is visible after removing the fluff fil-
ter in the plinth. This filter surface must
only be cleaned if there is a visible accu-
mulation of fluff.
 Carefully vacuum up any visible fluff
or soiling. Use a dusting brush or the
narrow crevice nozzle.
If there are visible blockages or other
residues after cleaning: remove the
filter insert and clean it under running
water. If stubborn residues are not
removed, these can lead to faults
over time.
Cleaning and care

Removing the filter insert

If the filter insert is clogged up and
soiled, it must be removed and cleaned
under running water.
 Use the handle to pull out the filter
insert at an angle forwards and to the
right.
 Then pull the filter insert out at an
angle.
 Rinse the filter surface of the insert
under warm running water.
Wet filters could cause operational
faults while drying.
Shake the filter insert thoroughly and
then dry it carefully.
63