Table of Contents
Advertisement
Dynamic radar cruise control
2
1
1
Driving assist mode select switch
2
Driving assist switch
3
"+" switch / "RES" switch
4
"-"
switch
Cancel
switch
5
Vehicle-to-vehicle distance switch
6
1
Press button
the desired speed (approximately 30 km/h or more),
"Dinamic radar cruise control" appears in the central sector
for a few seconds. Press button
The green symbol
green memorized speed above it and blue distance lines.
The stored speed can be varied using the
button
"+ RES" and button
3
To change the set vehicle speed, press the "+" or "-" switch
until the desired speed is displayed.
The set vehicle speed will increase or decrease as follows:
Short press adjustment: By 1 km/h (0.6 mph) or 1 mph
(1.6 km/h) each time the switch is pressed
Long press adjustment: Increases or decreases in 5 km/h
(3.1 mph) or 5 mph (8 km/h) increments continuously
while the switch is pressed and held
Canceling/resuming control
1 - Press the cancel switch or driving assist switch to cancel control.
Control will also be canceled if the brake pedal is depressed.
If the vehicle has been stopped by system control, depressing the brake pedal will not cancel control.
2 - Press the "RES" switch to resume control.
Sorbo Luigi
3
5
6
This dynamic radar cruise control detects the presence of
vehicles ahead, determines the current vehicle-to-vehicle
distance, and operates to maintain a suitable distance
from the vehicle ahead.
The desired vehicle-to-vehicle distance can be set by
operating the vehicle-to-vehicle distance switch
Use the dynamic radar cruise control only on highways
and expressways.
4
until selecting
and then accelerate to
2
to confirm.
50
appears on the display with the
"-"
4
1st Message in the central sector
Push
Driving Support System
Driving Support System
2nd Message in the central sector
27
50
km/h
D
Adaptive Cruise Mode
Adaptive Cruise Mode
50
km/h
D
to Activate
to Activate
Ver.001 del 04/12/23
6
.
50
Advertisement
Table of Contents
