Tpws Setting (Tyre Pressure Warning System) - Toyota COROLLA 2023 System User Manual

TPWS Setting (Tyre Pressure Warning System)

When replacing tires or wheels, tirepressure warning valves
and transmitters must also be installed.
When new tire pressure warning valves and transmitters are
installed, new ID codes must be registered in the tire pressure
warning computer and the tire pressure warning system must
be initialized.
1) Park the vehicle in a safe place and turn the power switch off,
wait for approximately 20 minutes or more, and then start the
hybrid system. The ID code registration procedure cannot be
performed while the vehicle is moving.
2) Select of the multi-information display and then press OK.
á â
3) Press or
á â
4) Press or
á â
5) Press or
á â
6) Press or
á â
7) Press or
ID codes will be registered to the displayed wheel set.
Registration of the position of each wheel after performing a
tire rotatio
1 - Park the vehicle in a safe place and turn the power switch off,
wait for approximately 20 minutes or more, and then start the
hybrid system. The wheel position registration procedure cannot
be performed while the vehicle is moving.
2 - Select of the multi-information display and then press .
á â
3 - Press or
á â
4 - Press or
á â
5 - Press or
6 - Select "OK" and then press OK. A message indicating that wheel
position registration is being performed will be displayed on the
multi-information display. "---" will be displayed for the tire inflation
pressure of each tire and wheel position registration will begin.
7 - Drive straight (with occasional left and right turns) at
approximately 40 km/h (25 mph) or more for approximately
10 to 30 minutes.
When wheel position registration is complete, a message indicating
that registration has been completed and the inflation pressure of
each tire will be displayed on the multi-information display.
Sorbo Luigi
to select "Vehicle Settings" and then hold OK.
to select "TPWS setting" and then press OK.
to select "Tire Set Switching" and then press OK.
to select "Register New Valve/ID" and then press OK.
to select "Tire Set 1" or "Tire Set 2". Then press OK.
to select "Vehicle Settings" and then press and hold.
to select "TPWS setting" and then press.
to select "Tire Rotation" and then press.
16
Settings
2
Hold OK to Change Settings
Vehicle Settings
Break Suggestion
DRCC/Speed Limiter
PBD
TPWS Setting
Push OK to Change
Settings
TPWS Setting
Tyre Set Switching
Tyre Rotation
Tyre Pressure Setting
Pressure Unit Setting
:Register replaced valve / ID
OK
Tyre Set Switching
Register New Valve / ID
Register Valve / ID
OK :Registering new valve / ID
TPWS Setting
Tyre Set Switching
Tyre Rotation
Tyre Pressure Setting
Pressure Unit Setting
OK :Reset Tyre Location
Tyre Rotation
OK?
Yes
No
:Select
OK
Ver.001 del 04/12/23