Table of Contents
Advertisement
DRCC / Speed limiter
DRCC(RSA) allows you to (almost) automatically adjust the
speed (with active "cruise control" or "Speed Limiter") to that
indicated by the detected road signs. The "almost" is because
you need to confirm the warning that appears in the box that
you want to increase or decrease the speed with "+ RES" or
"-" respectively.
If you have RSA (Road Sign Assist) enabled, when you go
with the radar cruise to 30 km/h, for example when you are
driving your car and the system detects a signal of 50 km/h
on the dashboard, the signal of 50 km/h appears surrounded
by a green color
+RES for 2 seconds the car automatically increases the speed
up to 50 km/h (the same for reducing the speed but with
"-" push button).
When the set vehicle speed is lower
than the detected speed limit
Press and hold the "+RES" switch
When the set vehicle speed is higher
than the detected speed limit
Press and hold the "-" switch
To exit the settings, press the back button
Sorbo Luigi
â
1) Press the
key to bring up the settings menu.
2) Choose the memory location between 1, 2 or 3
à
ß
with the
or
keys to configure the display
you want to personalize, then press OK.
â
Press the
key to choose DRCC/Speed Limiter
and then the OK botton to change settings
with an up
or down
50
arrow , if you press
50
50
As soon as a speed limit sign is
detected, a warning appears
for a few seconds in the central
sector
O
until you reach the settings menu.
13
Settings
2
Hold
OK
to Change Settings
Vehicle Settings
Break Suggestion
DRCC/Speed Limiter
PBD
TPWS setting
Push
OK
to Change Settings
DRCC/Speed Limiter
DRCC(RSA)
Speed Limit Offset
-
±
Overtake Prevention
Acceleration Setting
OK
:System ON/OFF
50
50
km/h
D
Hold
Hold
+RES
+RES to Set
to Set
50km/h
50km/h
Ver.001 del 04/12/23
0
+
50
Advertisement
Table of Contents
