Table of Contents
Advertisement
DRCC / Speed limiter
Curve speed reduction function
When a curve is detected, the vehicle speed will begin being
reduced.
When the curve ends, the vehicle speed reduction will end.
Depending on the situation, the vehicle speed will then return
to the set vehicle speed.
In situations where vehicle-to-vehicle distance control needs
to operate, such as when a preceding vehicle cuts in front of
your vehicle, the curve speed reduction function will be
canceled.
100
■Situations in which the curve speed reduction function may
not operate In situations such as the following, the curve speed
reduction function may no operate:
●When the vehicle is being driven around a gentle curve
●When the accelerator pedal is being depressed
●When the vehicle is being driven around an extremely short curve
Overtaking prevention function
If a detected vehicle in the passing lane is traveling slower than your
vehicle, overtaking will be suppressed.
The overtaking prevention function will not operate if the passing lane is congested
or vehicles are traveling at low speeds.
This function is not available for vehicles without a DCM.
DRCC/Speed Limiter setting
Overtake prevention
Acceleration setting
Speed setting (short press
Speed setting (long press)
Dynamic Radar Cruise Control
with Road Sign Assist
Speed limit offset
Guide message
Curve speed reduction
To exit the settings, press the back button
Sorbo Luigi
â
1) Press the
key to bring up the settings menu.
2) Choose the memory location between 1, 2 or 3
à
ß
with the
or
keys to configure the display
you want to personalize, then press OK.
â
Press the
key to choose DRCC/Speed Limiter
and then the OK botton to change settings
Change Setting
On, Off
High, Mid, Low
1 mph, 5 mph, 10 mph)
1 mph, 5 mph, 10 mph
On, Off
-5 to +5
On, Off
High, Mid, Low, Off
O
until you reach the settings menu.
14
Settings
2
Hold
OK
to Change Settings
Vehicle Settings
Break Suggestion
DRCC/Speed Limiter
PBD
TPWS setting
Push
OK
to Change Settings
DRCC/Speed Limiter
DRCC(RSA)
Speed Limit Offset
-
±
Overtake Prevention
Acceleration Setting
:System ON/OFF
OK
DRCC/Speed Limiter
Speed Setting (Push)
±
Speed Setting (Hold)
±
Guide message
Curve Speed Reduction
:Speed Setting (Push)
OK
±1/ 5/ 10
± ±
Ver.001 del 04/12/23
0
+
1
5
Advertisement
Table of Contents
