Welding A Tube Film - Silvercrest 416131 2210 Operating Instructions Manual

Welding a tube film

NOTES ON THE FILM
► The film width may not exceed 30 cm . Otherwise it cannot be welded
correctly .
► Use only nylon PA/PE films with a structure (dots or grooves) on one side
and a thickness of approx . 0 .17–0 .29 mm (170–290 μ) in this device .
Otherwise, the weld seam will not be tight and the appliance may be
damaged . You can recognise films of this type from the information on the
packaging . The quality of the weld seam will vary depending on the type
and thickness of the film .
► The supplied film is suitable for temperatures between -20°C and +110°C .
►
1) Cut the desired length for your bag from the tube film using a pair of scissors .
Cut as straight as possible .
2) Open the appliance lid 1 by pressing the lid release 8 and opening the
lid 1 upwards .
3) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5 . The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7 . If the bag lies over one or both of the two limiters 6/7, then the
bag cannot be correctly welded .
SV 125 C6
The supplied foil is BPA-free and microwaveable . However, never
heat completely sealed bags in the microwave . The bag could
burst! One side of the bag must be open . Heat the bags for no
more than 3 minutes at a maximum temperature of 900 W .
GB │ IE │ 9 ■