Welding A Tube Film - Silvercrest SFS 110 A1 Operating Instructions Manual

Welding a tube film
GB
MT
40
NOTES ON THE FILM
► The film width may not exceed 28 cm. Otherwise it cannot be welded
correctly.
► Use only nylon-PE films with a structure (points or grooves) on one side and
that have a structure (points or grooves) on one side and a thickness of
approximately 0.17 - 0.29 mm (170 - 290 μ).
Otherwise the weld seam will not be tight and the appliance may be da-
maged. You can recognise films of this type from the information on the
packaging. The quality of the weld seam will vary depending on the type
and thickness of the film.
► The supplied film is suitable for temperatures between -20°C and +100°C.
1) Cut the desired length for your bag from the tube film using a pair of scissors.
Cut as straight as possible.
2) Open the appliance lid
lid upwards.
3) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring
be inserted no further than the rear limiters
limiters . If the bag lies over one or both of the two limiters
bag cannot be correctly welded.
by pressing the lid release
and must lie between the front
and opening the
. The bag should
, then the
SFS 110 A1