Re-Install The Full Bed - Toro 07363 Operator's Manual

Air cooled gas utility vehicle
Table of Contents

Advertisement

2
Remove Full Bed
No Parts Required
Procedure
1. Start engine. Engage hydraulic lift lever and lower
bed until cylinders are loose in slots. Release lift lever
and turn off engine.
2. Remove lynch pins from outer ends of cylinder rod
clevis pins (Figure 4).
1. Bed mounting plate
2. Cylinder rod end
3. Clevis pin
3. Remove clevis pins securing cylinder rod ends to
bed mounting plates by pushing pins towards inside
(Figure 5).
4. Remove lynch pins and clevis pins securing pivot
brackets to frame channels (Figure 5).
5. Lift bed off vehicle.
The full bed weighs approximately 325 pounds,
so do not try to install or remove it by yourself.
Use an overhead hoist or get the help of two or
three other people.
Figure 4
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots (2/3 bed)
6. Store cylinders in storage clips. Engage hydraulic lift
lock lever on vehicle to prevent accidental extension
of lift cylinders.
3

Re-Install the Full Bed

No Parts Required
Procedure
Note: If bed sides will be installed on flat bed, it is
easier to install them before bed is installed on vehicle.
Note: Assure rear pivot plates are bolted to the bed
frame/channel so that lower end angles to the rear
(Figure 5).
1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
The full bed weighs approximately 325 pounds,
so do not try to install or remove it by yourself.
Use an overhead hoist or get the help of two or
three other people.
Note: Make sure the spacer brackets and wear blocks
(Figure 6) are installed with the carriage bolt heads
positioned inside the machine.
14
Figure 5
4. Clevis pin
5. Lynch pin

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman 3100

Table of Contents