Toro 07363 Operator's Manual page 48

1. Disconnected hoses
• On the other vehicle, connect the two hoses to the
coupler still in the coupler bracket (Connect the top
hose to the top coupler and the bottom hose to the
bottom coupler (Figure 63). Cap unused fittings.
1. Jumper hoses
• Keep all bystanders away from the vehicles.
• Start second vehicle and move lift lever to the raise
position which will raise the disabled box.
• Move the hydraulic lift lever to the neutral position
and engage the lift lever lock.
• Install the bed safety support onto the extended lift
cylinder. Refer to Using the Bed Safety Support.
Note: With both the vehicles turned off, move
the lift lever back and forth to remove the system
Figure 62
2. Jumper hoses
Figure 63
pressure and ease the disconnection of the quick
couplers.
• After completing operation, remove jumper hoses
and connect hydraulic hoses to both vehicles.
Important: Check hydraulic fluid levels, in both
vehicles, before resuming operation.
48