Table of Contents
Advertisement
Push on the side of the tab marked PUSH behind
1.
the rail, and push the rail to the rear.
Press and hold PUSH
2.
wards
until the front retainer
a
Pull the rail out towards the front.
3.
Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 26
and swing the rail out-
is detached.
Note:
Further information:
25.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
Guide the pull-out rail with the rear retainer
1.
below behind the two guide rods for the required
shelf position and keep it horizontal.
Guide the rail lengthways to the rear to the guide
2.
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
3.
Press and hold PUSH
inwards
until the retainer
lower rod.
a
Rails en
from
to grip the ver-
and swing the pull-out rail
is attached in the
37
Advertisement
Table of Contents
