Kohler LOURE 98452T-CP Installation Instructions Manual
Kohler LOURE 98452T-CP Installation Instructions Manual

Kohler LOURE 98452T-CP Installation Instructions Manual

Wallmount sensor faucet
Hide thumbs Also See for LOURE 98452T-CP:

Advertisement

Quick Links

安装说明书
安装之前
所有的资料是按最新出版的产品资料编写而成。
科勒公司保留任何时候不经通知即可改变产品特
性、包装或产品可供类型的权利。
说明书包括重要的安装、保养及清洁方面的内容,
请把这些资料交给用户阅读。
注意事项
1. 一定要先彻底冲洗供水管以清除管道中的杂
质,使用水源为自来水或可供饮用水。
2.请勿将强大的冲击力施于产品,以免造成损
害,引起故障。
3.安装、清洁龙头时,切勿损伤感应窗口表面,
以免造成故障。
4.如果是安装新的洗面盆,可将水龙头和排水
组件先安装好到面盆上。
5. 对于直流龙头, 安装时注意电池的正负极不
能装反,电池盒盖要拧紧,防止电池受潮。
6. 对于交流龙头,安装时务必按照说明书的要
求正确连接导线,龙头安装完毕后才可向电源盒
供电。
7. 一个交流电源盒最多可供一个感应龙头。
8. 修理面盆时,用黑色电工胶布粘住感应窗口。
9. 维修交流龙头时,必须断开交流电源并关闭
水源。
1205259-2-F
LOURE WALL MOUNT SENSOR FAUCET-AC
LOURE WALL MOUNT SENSOR FAUCET-DC
静安
Wallmount Sensor Faucet
BEFORE YOU BEGIN
All information is based on the latest product information
available at the time of publication, Kohler Co. reserves the
right to make changes in product characteristics, packaging,
or availability at any time without notice. Please leave these
instructions for the consumer. They contain important
installation, maintenance and cleaning information.
Notes:
1. Flush the water supply pipes thoroughly to remove debris.
Faucet is designed for tap water or potable water.
2. Do not attack the faucet with rough strength to avoidbeing
damaged and failure.
3. Do not damage the surface of sensing window when
installing or cleaning the faucet.
4. For new installations, install the faucet and drain onto
the lavatory before installing the lavatory.
5. As for DC type faucets, please pay special attention to the
battery poles direction. Tighten the battery cover completely
to prevent its exposure to moisture.
6. As for AC type faucets, strictly follow indicated instructions
to perform electric connection. Only provide electric supply
to power box after the installation is completed.
7. On e AC/DC transformer for max. one faucet.
8.Cover the sensing window with black tape when repairing
lavatories.
9.Turn off the electrical source and shut down water supply
before servicing faucet.
1
萝瑞
LOURE
2014
2014

Advertisement

Table of Contents
loading

Summary of Contents for Kohler LOURE 98452T-CP

  • Page 1 安装之前 BEFORE YOU BEGIN 所有的资料是按最新出版的产品资料编写而成。 All information is based on the latest product information available at the time of publication, Kohler Co. reserves the 科勒公司保留任何时候不经通知即可改变产品特 right to make changes in product characteristics, packaging, 性、包装或产品可供类型的权利。 or availability at any time without notice. Please leave these 说明书包括重要的安装、保养及清洁方面的内容,...
  • Page 2 使用说明 OPERATION INSTRUCTIONS Put your hand in the sensing –range (sensing 手伸到出水口下方感应范围内 range shall be auto adjusted per surrounding (感应距离随面盆、周围的情况 condition), the faucet should be on. The faucet 而自动调节),水龙头出水。手 should auto turn off after hand removal within 离开后0.5~1秒,水龙头自动 0.5~1 seconds. 止水。...
  • Page 3 ROUGH-IN 安装尺寸 K-98452T-CP 16305-NA 萝瑞墙出水感应龙头(交流) (单冷型) AC/DC transformer 完整墙面 交流电源盒 Whole metope 台盆顶面 G1/2 用户自备 Please prepare 穿线管 external thread angle valve G1/2 输出: 输入: 直流电压6V 交流电压 K-98453T-CP 24484T-NA 萝瑞墙出水感应龙头(直流) (单冷型) DC Power Unit 排水组件 完整墙面 直流电源盒 Whole metope 台盆顶面 G1/2 用户自备...
  • Page 4: Installation

    INSTALLATION 1. Install Mounting Bracket Assy. 一 安装暗装架组件 Determine installation method per lavatory 根据台盆大小确定安装方式,确保 size, and make sure the center of faucet 龙头出水中心正对台盆中心位置。 outlet aligns with the center of the lavatory. 1. Chisel out a Slot 1. 凿挖安装槽坑 Determine the installation lacation per 根据安装尺寸图确定安装位置,凿...
  • Page 5 Fill slurry into the slot and drill holes on 用灰浆填埋槽道,在瓷砖上打好孔 tiles as shown in the figure. 张贴瓷砖后的墙面如图。 2. Install Faucet 二 安装龙头 1. 拧下自攻螺钉(1),拔出灰浆 Remove the self-tapping screws (1) and slide the slurry mold (2) off the 模套(2)。 body. 2. 将龙头的进水软管和线束穿入 Make faucet water pipe and wire through mounting bracket, screw and 安装支架,由出线管穿出,将龙...
  • Page 6 4. Fix the control box 4. 控制阀组件的安装固定 Remove the cover (6) after loose the 用螺丝刀拧下阀盒盖螺钉(7),将 screws (7). Determine the installation 阀盒盖(6)打开。根据安装尺寸图 location of control box (5) per rough-in, 确定控制阀组件(5)安装位置, then drill holes and place sheath (8) in it. 打孔,打入膨胀管(8),使阀盒 Make the control box cling on the wall 紧贴墙面且控制阀组件方向,再...
  • Page 7 2. Connect power cords with corresponding color wires, then place battery box assembly to empty space within control assembly then fasten control box by screws based on installation direction. For AC faucet, except corresponding cords connect to AC/DC transformer output, other installation methods are identical.
  • Page 8 HOW TO INSTALL THE AC/DC 如何安装交流电源盒 TRANSFORMER (ONLY USED (若用户另购交流电源盒, WITH TOUCHLESS FAUCET, AC) 具体安装详见其说明书) 一个交流电源盒供一个感应龙头 Wire connection pattern for one to one 感应龙头 Faucet G1/2 Please prepare external thread angle valve G1/2 交流电源盒 AC/DC transformer 220V交流电Connect AC 220V 穿线管 Wire Tube 开关...
  • Page 9 1.电源盒 (背面有不干胶)应安装在干燥,不会被水 1. AC power unit (sticker on the back) should be installed at a dry place, and avoid showering, soaking from water. 淋湿、浸泡的位置。根据需要客户自备穿线管及 Customer prepare wire tube and wire according to 连接线。穿线管安装在墙内。建议交流电源线采用 requirement. Wire tube should be put into the wall. 带绝缘和护套层的电线,导体标称截面积...
  • Page 10 G1/2 三通软管组件 Note: Please let users prepare the tee and angle valve 注:三通、角阀请用户自备。 by themselves. It is recommended to use Kohler TEE inlet hose assembly, 建议使用科勒推荐的三通进水软管 otherwise there is a risk of cold and hot water mixing 组件,否则有冷热水互窜的风险。 problem.
  • Page 11: Installation Checkout

    面。许多清洁剂,比如氨水,去污粉及洁厕灵 chlorine, toilet cleaner etc. which could adversely affect the 等,会对电镀表面造成伤害,切忌使用。 finish and are not recommended for cleaning. 有腐蚀性的清洁剂或溶剂不可使用于科勒的水龙 Do not use abrasive cleaners or solvents on Kohler faucets 头及其配件上。 and fittings. IMPORTANT CONSUMER INFORMATION 用户须知 1. Note of the Indicator Flashing 1.
  • Page 12 清洗过滤系统 Clean the Filtration System The touchless faucet control assembly include 该感应龙头的控制组件内已包含了过 filtration device. Poor water outflow shall be 滤网组件 caused by excessive impurities inside the hose 滤装置。如管内杂质过多或水质较 Filter Assy or poor water quality after long time use. Please 差,长期使用会引起出水情况不良。 clean filtration device per following steps: 请按以下步骤清洗过滤装置:...
  • Page 13: Troubleshooting

    Object in sensing range not flash Please contact with distributor or Kohler China Investment Co., Ltd., if the trouble remains after above-mentioned actions are taken. Please do not disassembly the other parts of the faucet freely except installing and replacing batteries.
  • Page 14 产品中有害物质含量的说明 回收提示 本产品超过使用期限或经过维修无法正常使用后,不应随意丢弃,请交由有废弃电器电子产品处理资质的 企业处理,正确的处理方法请查阅国家或当地有关废旧电器电子产品处理的规定。 有害物质统计表 有害物质名称 部件名称 六价铬 多溴二苯醚 多溴联苯 铅(Pb) 镉(Cd) 汞(Hg) (Cr(VI)) (PBDE) (PBB) × ○ ○ ○ ○ ○ 外壳组件 × ○ ○ ○ ○ ○ 阀体组件 ○ ○ ○ ○ × ○ 控制盒组件 ○ ○ ○ ○...
  • Page 15 :Indicate only partial product series contains this substance. Note: the information provided is based on the supplier data and Kohler inspection results. The product is designed not to hurt the environment. Under current technology, all hazardous materials have been used in the smallest amounts possible. Kohler will strive to reduce the use of these hazardous materials used in this product.

This manual is also suitable for:

Loure 98453t-cp

Table of Contents