Kohler LOURE 98452T-CP Installation Instructions Manual page 9

1.电源盒 (背面有不干胶)应安装在干燥，不会被水
淋湿、浸泡的位置。根据需要客户自备穿线管及
连接线。穿线管安装在墙内。建议交流电源线采用
带绝缘和护套层的电线，导体标称截面积 0.5mm ;
直流连接线采用导体标称截面积
请严格按照上图进行连接。
2. 排线完毕后，应检查并确保所有排、接线无误，
再分别连接电源盒AC接线端与排线管内交流接线
端，以及电源盒DC接线端(黑橙线接头)与龙头的
电源线接插件（从阀盒内引出的电线），最后打
开AC电源，龙头进入30秒自动调距阶段，此过
程龙头不会出水。
如何安装超能动电池系统(若用户
另购超能动电池K-13683T,具体安
装详见其说明书)
1. AC power unit (sticker on the back) should be installed at
a dry place, and avoid showering, soaking from water.
Customer prepare wire tube and wire according to
requirement. Wire tube should be put into the wall.
2
Suggested wire:AC connection wire should with insulated
mm 的电线。 2
0.3
protecting layer or sleeve and the section should ≥ 0.5mm².
The section of DC connection wire should ≥ 0.3mm².The
connection pattern must a ccording to illustrations above.
2. After wire layout finished, check and repair if needed.
Then connect AC connector of AC/DC transformer to
electrical source from the control box, and DC connector of
AC/DC transformer to faucet. Turn on AC electrical power,
Faucet will commence auto-sense mode which will take
30s. The faucet will not work this period.
HOW TO INSTALL THE HYBRID ENERGY
SYSTEM (If using hybrid energy system
K-13683T as power supply, please refer to
its installation instruction)
9
感应龙头
Faucet
台盆顶面
G1/2
Please prepare
external thread
angle valve G1/2
超能动电池系统
1205259-2-F