Kohler Loure 98452T-CP Installation Instructions Manual
Kohler Loure 98452T-CP Installation Instructions Manual

Kohler Loure 98452T-CP Installation Instructions Manual

Wallmount sensor faucet
Hide thumbs Also See for Loure 98452T-CP:

Advertisement

Quick Links

安装说明书
98452T-CP
98453T-CP
安装之前
所有的资料是按最新出版的产品资料编写而成。
科勒公司保留任何时候不经通知即可改变产品特
性、包装或产品可供类型的权利。
说明书包括重要的安装、保养及清洁方面的内容,
请把这些资料交给用户阅读。
注意事项
1. 一定要先彻底冲洗供水管以清除管道中的杂
质,使用水源为自来水或可供饮用水。
2.请勿将强大的冲击力施于产品,以免造成损
害,引起故障。
3.安装、清洁龙头时,切勿损伤感应窗口表面,
以免造成故障。
4.如果是安装新的洗面盆,可将水龙头和排水
组件先安装好到面盆上。
5. 对于直流龙头, 安装时注意电池的正负极不
能装反,电池盒盖要拧紧,防止电池受潮。
6. 对于交流龙头,安装时务必按照说明书的要
求正确连接导线,龙头安装完毕后才可向电源盒
供电。
7. 一个交流电源盒最多可供两个感应龙头。
8. 交流电的总电源必须有合适熔断丝加以保护。
9. 请勿使产品感应窗口靠近强紫外线或电磁场。
10. 修理面盆时,用黑色电工胶布粘住感应窗口。
11.维修交流龙头时,必须断开交流电源并关闭
水源。
1205259-2-B
萝瑞入墙式单冷交流感应龙头(不带交流电源盒)
萝瑞入墙式单冷直流感应龙头
上海科勒电子科技有限公司
中国上海市宝山区丰翔路1955号 邮编:200444
Wallmount Sensor Faucet
BEFORE YOU BEGIN
All information is based on the latest product information
available at the time of publication, Kohler Co. reserves
the right to make changes in product characteristics,
packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They
contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
Faucet is designed for tap water or potable water.
2. Do not attack the faucet with rough strength to avoid
being damaged.
3. Do not damage the surface of sensing window when
installing or cleaning the faucet.
4. For new installations, install the faucet and drain to the
lavatory before installing the lavatory.
5.As for DC type faucets, please pay special attention to
insert direction match of battery poles. Tighten the battery
cover completely to prevent its exposure to moisture.
6. As for AC type faucets, strictly follow indicated instructions
to perform electric connection. Only provide electric supply
to power box after the installation is completed.
7. One AC/DC transformer for max.two faucets.
8. Electrical source must equiped with suitable fuse to
protect AC/DC transformer unit from damage.
9. Do not put the faucet near strong ultraviolet or
electromagnetic field.
10. Cover the sensing window with black tape when
repairing lavatories.
11.Turn off the electrical source and shut down water
supply before the faucets repaired.
1
萝瑞
LOURE
2014
2014

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Loure 98452T-CP and is the answer not in the manual?

Questions and answers

Summary of Contents for Kohler Loure 98452T-CP

  • Page 1 安装之前 BEFORE YOU BEGIN 所有的资料是按最新出版的产品资料编写而成。 All information is based on the latest product information available at the time of publication, Kohler Co. reserves 科勒公司保留任何时候不经通知即可改变产品特 the right to make changes in product characteristics, 性、包装或产品可供类型的权利。 packaging, or availability at any time without notice.
  • Page 2 使用说明 OPERATION INSTRUCTIONS Put your hand in the sensing -range, the faucet 手伸到出水口下方感应范围内 should turn on. The faucet should turn off after (感应距离随面盆、周围的情况 removal within 0.5~1 seconds. The sensing 而自动调节),水龙头出水。手 distance will be adjusted automatically as per the 离开后0.5~1秒,水龙头自动止 condition of the lavatory and surrounding 水。...
  • Page 3 安装尺寸 ROUGH-IN 98452T-CP 萝瑞入墙式单冷交流感应龙头 16306-NA 90~115 完整墙面 AC/DC transformer Whole metope 交流电源盒 台盆顶面 Vessel rim Max 10cm 用户自备 32 用户自备角阀 穿线管 G1/2外螺纹 Please user prepare external thread angle valve G1/2 Output: DC3V Input:AC220V 输出: 输入: 直流电压3V 交流电压220V 98453T-CP 萝瑞入墙式单冷直流感应龙头 排水组件 Drain 90~115 完整墙面...
  • Page 4: Installation

    INSTALLATION 1. Install Mounting Bracket Assy. 一 安装暗装架组件 Determine installation method per 根据台盆大小确定安装方式,确保 lavatory size, and make sure the center 龙头出水中心正对台盆中心位置。 of faucet outlet aligns with the center of the lavatory. 1. 凿挖安装槽坑 1. Chisel out a Slot Determine the installation lacation per 根据安装尺寸图确定安装位置,凿...
  • Page 5 Fill slurry into the slot and drill holes 用灰浆填埋槽道,在瓷砖上打好孔 on tiles as shown in the figure. 张贴瓷砖后的墙面如图。 2. Install Faucet 二 安装龙头 1. 拧下自攻螺钉(1),拔出灰浆 1. Remove the self-tapping screws (1) and slide the slurry mold (2) off the 模套(2)。 body. 2.
  • Page 6 4. Fix the control box 控制阀组件的安装固定 Remove the cover (6) after loose the 用螺丝刀拧下阀盒盖螺钉(7),将 screws (7). Determine the installation 阀盒盖(6)打开。根据安装尺寸图 location of control box (5) per rough-in, 确定控制阀组件(5)安装位置,打 then drill holes and place sheath in it. Make the control box cling on the wall 孔,打入膨胀管,使阀盒紧贴墙...
  • Page 7 Finally, connect the red-green wires of 最后,将电磁阀上的红绿线与对应阀 solenoid valve and cover of valve box, 盒盖组件上的红绿线接插,将电池盒 then connect the black-orange wires of 或交流电源盒上黑橙线与主控板组 battery box and control board ( If you 件上黑橙线接插,(交流版请将主 faucet is AC version, please let the black-green wires of the control board go 控板组件上的黑橙线从小U型缺口...
  • Page 8 HOW TO INSTALL THE AC/DC 如何安装交流电源盒 TRANSFORMER (ONLY USED (若用户另购交流电源盒, WITH TOUCHLESS FAUCET, AC) 具体安装详见其说明书) 一个交流电源盒供一个感应龙头 Wire connection pattern for one to one 感应龙头 Faucet 交流电源盒 AC/DC transformer 用户自备角阀 接220V交流电 G1/2外螺纹 Connect AC 220V Please user prepare external thread angle valve G1/2 穿线管...
  • Page 9 1.电源盒 (背面有不干胶)应安装在干燥,不会被水 1. AC power unit (sticker on the back) should be installed at a dry place, and avoid showering, soaking from water. 淋湿、浸泡的位置。根据需要客户自备穿线管及 Customer prepare wire tube and wire according to 连接线。穿线管安装在墙内。建议交流电源线采用 requirement. Wire tube should be put into the wall. 带绝缘和护套层的电线,导体标称截面积...
  • Page 10 HOW TO CHANGE TO MIXING SENSOR 如何转换成混水感应龙头 (若用户另购三通软管组件 FAUCE (If users buy the tee hose assy 1240574-SP) 1240574-SP) 用户自备角阀 用户自备角阀G1/2外螺纹 G1/2外螺纹 Please user prepare Please user prepare external thread angle valve external thread angle valve G1/2 G1/2 三通软管组件 Tee hose assy HOW TO CHANGE TO THERMOSTATIC 如何转换成恒温阀感应龙头...
  • Page 11: Installation Checkout

    许多清洁剂,比如氨水,去污粉及洁厕灵等,会 chlorine, toilet cleaner etc. which could adversely affect the 对电镀表面造成伤害,切忌使用。 finish and are not recommended for cleaning. 有腐蚀性的清洁剂或溶剂不可使用于科勒的水龙 Do not use abrasive cleaners or solvents on Kohler faucets and fittings. 头及其配件上。 IMPORTANT CONSUMER INFORMATION 用户须知 1. Note of the Indicator Flashing 1.
  • Page 12 3.自动止水智能控制 3. Intelligent Stopping Flowing Water will flow out when object is detected in the sensing 物体进入感应范围内被感知,龙头自动出水。若 range. If the objects hold still for 15 seconds, the faucet 15秒钟静止不动,水龙头自动止水。自动止水后, will shut off automatically. After that, objects must be 手或物体离开感应范围后,再次进入感应范围内, removed from the sensing range. Then the water will flow 水龙头正常工作,否则无反应。...
  • Page 13: Troubleshooting

    Please contact with distributor or Kohler China Investment Co., Ltd., if the trouble remains after above-mentioned actions are taken. Please do not disassembly the other parts of the faucet freely except installing and replacing batteries.
  • Page 14: Service Parts

    萝瑞 LOURE SERVICE PARTS 零 件 图 Wallmount Sensor Faucet 1035611-SP-CP Drain 排水器组件 2.5mm Hex Wrench 2.5mm 内六角扳手 1.5mm Hex Wrench 1168047-SP 1.5mm 内六角扳手 Installation Assy 安装组件 1198218-SP-CP 16306T-NA Spout AC/DC Transformer 壳体 (Only for 98452T-CP) 1198220-SP-CP 交流电源盒 Inlet Hose Escutcheon (仅用于...

This manual is also suitable for:

Loure 98453t-cp

Table of Contents