Table of Contents
Advertisement
10
Setting up the machine
Threading the upper thread
A
Attaching the thread spool
· raise the needle and presser foot
· turn the power switch to "0"
· place spool on pin
· attach the appropriate spool disc – diameter
of spool = disc size
· take thread through rear guide A
· then into slit of upper thread tension
Down
· pull thread down to the right of the take-up cover to B
Up
· take thread up to the left of the cover to C in the
direction of the arrow, placing it in the take-up lever
Down
· take thread down and through guides D and E
Needle threader
A
Thread in hook
· lower the presser foot
· lay the thread behind
hook A and hold lightly
Bringing up the lower thread
B
Lever down
· press lever B down
Bringing up the lower thread
· if bobbin thread is cut on the cutter (page
8), there is no need to bring it up
· hold the upper thread
· sew one stitch
· pull the upper thread to bring the lower
thread up through the stitch plate hole
· take both threads through the slit on the
presser foot to the back
· pull threads over the cutter
C
D
B
E
C
Thread in front of needle
· take the thread in front
of the needle C
· pass the thread from the
bottom to the top of the
needle until it catches in
the hook
C
D
E
Refer to the safety
instructions!
Let go of lever and thread
· let go of lever B and
thread
· pull the thread loop
through the needle eye
Note:
The bobbin thread must be
brought up through the
stitch plate for certain
types of work. The length
of thread is sufficient for
most normal work if the
lower thread cutter has
been used.
Advertisement
Table of Contents
