Table of Contents
Advertisement
Power cable
A
C
Foot control
Power switch
Sewing table
FHS (Free Hand System) presser foot lifter
Power cable
· the power cable is stored in the case
· plug A into machine
· plug B into electrical outlet
Foot control cable
· plug C into machine
B
Sewing speed
· control the sewing speed
by depressing the foot
control with your toe
· raise or lower the needle
by tapping on the foot
control with your heel
Use only foot controller
type LV1/LV2 for sewing
machine model 170/180
(USA/Canada only)
Power switch
The power switch is on the
handwheel side of the machine
1 the machine is switched on
0 the machine is switched off
The sewing light is switched on
and off within the Setup
program.
Larger sewing surface
· the sewing table
increases the sewing
surface
· free arm for larger
tubular items such as
pant legs and waistbands
Raising and lowering the
presser foot
· the presser foot lifter
raises and lowers the
presser foot
· push to the right with
your knee
· the presser foot is raised
and the feed-dogs are
lowered simultaneously
· the feed-dogs come up
automatically as soon as
the first stitch is sewn
Important! (USA/Canada only)
This sewing machine has a polarized plug
(one blade wider than the other). To
reduce the risk of electric shock, this plug
is intended to fit only one way into a
polarized outlet. If the plug does not fit
fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician to install the proper outlet. Do
not modify the plug in any way.
A
B
C
To attach
· push over the free arm
and press firmly so that it
engages on the fixing lug
(needle and presser foot
fully raised)
To remove
· pull to the left
· remove by pulling it
completely from the
free arm
Attaching the presser foot
lifter
· the presser foot lifter is
stored in the case.
· insert the presser foot
lifter into the opening in
the base plate
· you should be able to
operate the lifter in your
normal sitting position.
Setting up the machine
Cable tidy
· wind the cable round the
spool
· insert the plug into A
When sewing
· unwind the cable to the
desired length and slip
into B or C
Refer to the safety
instructions!
Seam guide
· insert into the groove
(underside of table) from
the right
· it can be freely adjusted
over the whole width of
the table
Scale
· number "0" corresponds
to the center needle
position
Note:
Your dealer can adjust the
position if necessary
7
Advertisement
Table of Contents
