Table of Contents
Advertisement
10
LIGHTING INSTRUCTIONS
WARNING: NEVER put hands or face directly over the burner while
lighting or while the unit is in operation.
1.
Connect the gas hose to LP cylinder and check all connections
for leaks.
Note: Keep the LP cylinder at least 24" away from the unit.
2. Make sure the regulator control is turned OFF by turning
counterclockwise until it cannot be turned any further.
3. Open LP cylinder control valve by turning it counterclockwise (Fig. 1).
4. If using a lighter: Insert through the hole in the shroud (Fig. 2).
If using a match and match holder: Hold in the top of the range
above the burner (Fig. 3).
5. Turn the regulator control toward the ON position until ignition occurs.
Note: Turning the regulator control clockwise increases the gas
pressure to the burner, which will increase the flame size (Fig. 1).
Note: If ignition does not occur within 3-5 seconds, turn the regulator
and cylinder valve OFF. Wait 5 minutes to allow gas to disperse, then
repeat the above process.
6. Check that the flame is blue, indicating proper gas flow. If your
flames are orange/yellow, rotate the air shutter (Fig. 4) until there is
a blue flame.
Note: Opening the shutter too far will cause the flame to "lift" off
the burner.
7.
Monitor the range at all times during operation. If at any point the
flames are accidentally extinguished, immediately turn the regulator
and cylinder valve OFF. Wait 5 minutes for gas to disperse, then
relight the range according to the above instructions.
OPERATION & MAINTENANCE
•
Follow all Lighting Instructions above each time the cooker is used. Check the flame for proper color and
appearance. The flame should burn with a primarily blue color. If a strong yellow flame is present, this could
indicate an obstruction in the burner/venturi tube. If there is any obstruction or a yellow flame, and the air
shutter adjustment has not solved the problem, turn off the cooker and allow time for it to cool. Disconnect
the hose from the cooker. Remove the air shutter using a phillips head screwdriver. Check the venturi tube
with a flashlight to see if there is a blockage. If a blockage is present, use a wire such as a coat hanger to
slide into the venturi tube to remove the blockage. Reattach the air shutter to the venturi tube using the
phillips screwdriver. Assemble and light the cooker again as per the instruction manual.
•
Always use the LP hose/regulator assembly supplied with the appliance.
•
For purchase of any replacement parts, please visit WebstaurantStore.com.
•
DO NOT place an empty aluminum or stainless steel pot on a lit cooker. A hole will be burned in the bottom
of the pot. Discoloration, scratching, and dimpling may occur with the use of pots on outdoor cookers. This
does not affect the performance of the pot.
•
DO NOT store used oil inside your aluminum pot. The salt used in cooking can corrode the pot, causing it to
leak. Wash the pot after each use with hot, soapy water and rinse.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
Advertisement
Table of Contents
