Table of Contents
Advertisement
Reinsert the member card. The training can start now. If the maximum number of workouts is fulfilled a
new program has to get stored on the card.
The member card should be used by one training person only. After the desired program has been saved, the
card simply has to be entered to start the workout. The workout is controlled automatically and no further
programming is necessary. All workout results are saved automatically as average or accumulated values on the
storage media after each workout.
Special functions of the trainer card: Deleting the data on member media
If you want to delete all data of a medium, then you have to insert the trainer medium twice. Afterwards you
insert the member card. Then the monitor will indicate "delete card". If you insert the member card afterwards
the display will show "card expired."
If the member card is inserted in the monitor the results can get deleted without deleting the training program.
The "Results total" can be deleted by pushing the buttons + and – (3 seconds) at the same time. Solely the
results will get deleted, not the training plan.
Functioning of the member medium
The trainee must get onto the ergometer and begin pedalling. Next, the storage media has to be entered into
the slot. The accumulated/average results of previous workouts on all types of ergometers and for the type used
at the moment are shown for four seconds each.
After that, the personal workout that was previously saved on the storage media is being started automatically
and the workout session can begin. The storage media can be removed after the workout is over or interrupted
by pressing the COOL button.
The results of the actual session are displayed on the monitor and saved onto the storage media immediately
after the end of the workout.
4.10
Online-Training with RFID
As an option the units can get equipped with a RFID reader (Mifare, Hitag, Legic – Attention: Please take care of
the proper specifications when ordering. Solely with the right reader the compatibility will be given). The
online-version gets controlled with a compatible PC-Software.
To start the training there are different alternatives depending on the RFID-media.
Working with a RFID-card one has to insert the card into the reader for user identification and call of the
current workout. The training can start. Go is shown in the display.
Using a wristband one has to press the RFID-button. Then the wristband hast to get hold over the RFID-button.
The training can start. Go is shown in the display.
Using a media other then a RFID-card has to be announced before production of the units as special settings will
be needed.
Fig. 5: RFID-button for RFID identification, in case the medium cannot be read via the slot
If the message "insert again" is shown several times in a row, press the SCAN-button to display a more specific
error message.
/H-p-cosmos.local/dfs/erp$/article/cos30021ef-med600/manual/EN/20170926_cos30033ef-med600-ef-600_torqualizer_stair_instructions_for_use_EN.pdf
User manual motion stair 600 med/600
Page 9 of 19
RFID-Button
Version 3.0
Advertisement
Table of Contents
