Battery Lowering System And Manual Lowering Device; Reset Button - Savaria Vuelift Owner's Manual

Battery Lowering System and Manual Lowering Device

If a power failure occurs, a battery lowering system
will bring the Vuelift to the bottom level.
If the battery fails while operating, there is a manual
lowering device that can be used to bring the Vuelift
to a lower landing level as described below.
1 Turn off the main power disconnect.
2 Remove the aluminum snap cap cover on the right side of the top floor
landing door (above the top floor ring) using a ¾'' open-end wrench.
3 Insert the manual lowering tool (shown in Figure 4) into the hole provided
in the rail.
4 Turn the manual lowering tool until the unit is at the desired landing level.
5 Make sure the floor of the cab is level (within 2 inches) to the landing.
6 Use the special emergency key to manually open the landing door.

Reset Button

There is a reset button located on the cover of the
controller box.
In the event your Vuelift is not operating properly,
press the reset button for 3 seconds.
If this issue persists, please contact your
dealer/maintenance contractor for further
assistance.
Part No. 001122-CE, Rev. 001, 31-m01-2024
The manual lowering device is for emergency use
only. When manually lowering, ensure the car floor
is always within 2 inches (50 mm) of the landing
prior to opening the hoistway door. After use of
any emergency function (access key or manual
lowering device), ensure that all doors/gates are
secure and locked. While the emergency function
is in use, DO NOT leave the area unattended.
Figure 4
Vuelift Owner's Manual
7