Connect The Mppt Control Display - Victron energy SmartSolar MPPT 250/70 Manual

4. Remove the paper backing of the double sided tape on the back of the display.
5. Insert the display into the plug and make sure it has been inserted all the way in.
6. Screw the display down by using the two screws that were used for the plastic cover.
For more information, see the SmartSolar Control display manual
The display is hot-swappable, this means that the display can be plugged in or removed while the solar
charger is operating.

4.8. Connect the MPPT Control display

Connect the (optional) MPPT Control
The VE.Direct cable is available in a variety of lengths and is not included with the MPPT control display. Note that it is not
possible to extend the VE.Direct cable, the maximum length can not exceed 10 meters.
For more information, see the MPPT Control
Page 14
MPPT solar charger manual
How and where to connect the SmartSolar Control display
display to the VE.Direct port of the solar charger using a
manual.
Connect the display to the solar charger via a VE.Direct cable
VE.Direct cable.
Installation