Connect The Mppt Control Display - Victron energy BlueSolar MPPT 75/10 Manual

The correct connection order is necessary to allow the automatic system voltage detection to setup properly. It is only allowed to
connect PV first when the system voltage is manually set before connecting the battery. Not following the correct procedures can
disable or damage the charger and/or the installation.
See the below figure on how the basic electrical connections are made:
ID Description
A Solar charger.
B Battery or battery bank, lead acid or lithium.
C Solar panel or solar panel array.
D DC loads.
DC fuse.

4.7. Connect the MPPT Control display

Connect the (optional) MPPT Control
The VE.Direct cable is available in a variety of lengths and is not included with the MPPT control display. Note that it is not
possible to extend the VE.Direct cable, the maximum length can not exceed 10 meters.
For more information, see the MPPT Control
Page 13
MPPT solar charger manual
display to the VE.Direct port of the solar charger using a
manual.
Connect the display to the solar charger via a VE.Direct cable
VE.Direct cable.
Installation