Control And Adjustment; Monitor Menu - Victron energy Skylla-IP65 Manual

3. Control and Adjustment

When the charger is installed correctly, the charger should be set up to suit the battery connected.
To set up the charger, apply mains power and enter the setup menu by pressing "SETUP" for three seconds.
The charger will enter a standby mode (no power applied to the battery terminals) and the user can set up the unit accordingly.
See the next table for all possible adjustments.

3.1. Monitor menu

The monitor menu is visible when power is applied to the charger.
The following table shows the consecutive lines when scrolling through the menu with the up/down keys:
Displayed info
Battery voltage / current
Battery voltage
Battery charge current
*1
Battery temperature
Mains current
*2
Battery voltage out 1
*2
Battery charge current out 1
*2
Battery voltage out 2
*2
Battery charge current out 2
*2
Battery voltage out 3
Page 6
Skylla-IP65
Icons
1C
1
1
2
2
3
Segments
14 0
14.40
60.00
25.0,---,Err
3.6
14.4
60.0
14.4
60.0
14.4
Control and Adjustment
Units
A
V
A
°C/°F
A
V
A
V
A
V